STWBC2-HP
Datasheet
Digital controller for wireless battery charger transmitters
Features
•
•
Digital controller for Qi certified wireless power transmitters
–
–
–
–
Compliant with WPC 1.3
Power Class 0 BPP (5 W) and EPP (15 W)
Power Tx design topologies MP-A2 and MP-A22
Proprietary ST Super Charge extension for high power charging
SiP with uC and front end device:
–
–
–
–
–
–
–
–
ARM 32-bit Cortex™-M0+ CPU, frequency up to 64 MHz
3x half-bridge drivers
Embedded 3.6 V / 5 V DC-DC
3.3 V and 1.8 V LDOs
6 V to 9 V voltage doubler
Qi FSK programmable modulator
Integrated current, voltage and phase demodulators
Integrated current and voltage sensors.
•
Support for half- and full-bridge topologies with input DC-DC
–
–
Single and multi-coil topologies
Support for limited power sources such as 5 V 500 mA USB
•
•
VIN operative range: 4.1 V to 24 V
USB physical interfaces
–
USB power delivery
Product status link
•
Communication interfaces
–
–
–
–
UART
STWBC2 -HP
SPI (up to 28 Mbit/s)
I2C (up to 1 Mbit/s)
Up to 8x GPIOs
Product label
•
•
Peripherals
–
–
–
8-channel 12-bit 0.5 us ADC
Low side differential current sensor
Q-Factor driver
Memory
Table 1. Ordering information
–
–
128 Kbytes of Flash memory with ECC
32 Kbytes of SRAM with HW parity check
Order code
Package
Packaging
STWBC2-HP VFQFPN68 Tape & Reel
•
•
•
•
Development support: serial wire debug (SWD)
Operating temperature: -40°C up to 125°C.
Package: VFQFPN68L 8x8 mm pitch 0.4
96-bit unique ID
Description
The STWBC2 -HP is a digital controller specifically dedicated to design Qi-certified
Wireless Power TX applications. The STWBC2-HP is a SiP including an STM32™
microcontroller and an application-specific front-end die.
DS13825 - Rev 1.0 - September 2021
www.st.com
For further information contact your local STMicroelectronics sales office.