5秒后页面跳转
SLC100-33 PDF预览

SLC100-33

更新时间: 2024-02-28 08:59:17
品牌 Logo 应用领域
CANDD 转换器输出元件
页数 文件大小 规格书
10页 299K
描述
40 Amp SINGLE OUTPUT QUARTER BRICK DC / DC CONVERTER

SLC100-33 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
包装说明:,Reach Compliance Code:compliant
ECCN代码:EAR99风险等级:5.55
Is Samacsys:N模拟集成电路 - 其他类型:DC-DC REGULATED POWER SUPPLY MODULE
最大输入电压:75 V最小输入电压:36 V
标称输入电压:48 VJESD-30 代码:R-XDMA-P8
JESD-609代码:e3最大负载调整率:0.5%
功能数量:1输出次数:1
端子数量:8最高工作温度:100 °C
最低工作温度:-40 °C最大输出电压:2.75 V
最小输出电压:2.25 V标称输出电压:2.5 V
封装主体材料:UNSPECIFIED封装形状:RECTANGULAR
封装形式:MICROELECTRONIC ASSEMBLY峰值回流温度(摄氏度):NOT SPECIFIED
认证状态:Not Qualified表面贴装:NO
技术:HYBRID温度等级:INDUSTRIAL
端子面层:MATTE TIN端子形式:PIN/PEG
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
最大总功率输出:48 W微调/可调输出:YES
Base Number Matches:1

SLC100-33 数据手册

 浏览型号SLC100-33的Datasheet PDF文件第3页浏览型号SLC100-33的Datasheet PDF文件第4页浏览型号SLC100-33的Datasheet PDF文件第5页浏览型号SLC100-33的Datasheet PDF文件第7页浏览型号SLC100-33的Datasheet PDF文件第8页浏览型号SLC100-33的Datasheet PDF文件第9页 
APPLICATION NOTES  
To lower the converter output voltage a resistor must  
be placed between the Trim pin and -Vout pin as  
shown in Figure 3.  
Figure 4 – Remote ON/OFF Control Circuit  
Protective Functions  
Figure 3 – Trim Down Circuit  
Temperature Shutdown  
The resistance value required to achieve the desired  
amount of positive/negative trim can be determined  
by referring to the trim table for each model. If trim-  
ming is not desired then the Trim pin may be left  
open. In addition to the resistor values provided in  
the trim tables, the following equations can be use  
to calculate the required resistor value for a desired  
output voltage. These equations apply for the 1.5V  
and above models. For 1.2V models the trim tables  
must be used.  
The over temperature shutdown feature of the  
SLC100 will cause the unit to shutdown at a typical  
pwb internal monitor point temperature of 135oC. This  
protective feature is comprised of a thermistor in the  
units control loop. At a temperature of 135oC this  
circuit will cause the PWM to go into an idle mode,  
resulting in no output from the converter and prevent-  
ing damage to the converter components. When the  
temperature of the unit drops below 125oC the fault  
condition will clear and the converter will resume nor-  
mal operation. If the cause of the over temperature  
condition is not identified and corrected the unit will  
continue to cycle on and off indefinitely.  
out  
5.11V (100+∆%) - 511 - 10.22 kΩ  
R
trim_UP  
=
(
)
V
ref ∆%  
∆%  
Vref=1.225  
5.11  
∆%  
Input Under-Voltage Shutdown  
-10.22 kΩ  
R
trim_down  
=
[
[
The nominal input voltage for the SLC100 is 48Vdc.  
Once turned on reducing the input voltage to 32.0 Vdc  
nominal will shut down the device. At an input voltage  
less than 32.0V the under-voltage sensing circuit will  
send a signal to the PWM causing it to go into idle  
mode. This will result in no output from the converter,  
protecting the unit from a high input current condition.  
When the input voltage returns to a level above 33.3V  
the unit will return to normal operation. The unit will  
typically turn on at an input voltage of between 33.3V  
and 34.5V nominal as indicated on the Product Data  
Sheet. This is due to hysterisis designed into the  
protective circuit to prevent excessive cycling of the  
converter.  
Remote ON/OFF Control Function  
The SLC100 is equipped with a primary ON/OFF pin  
used to remotely turn the converter on or off via a  
system signal. The input is TTL open-collector and/or  
FET open-drain compatible. For the positive logic  
model a system logic low signal will turn the unit off.  
For negative logic models a system logic high signal  
will turn the converter off. For negative logic models  
where no control signal will be used the ON/OFF pin  
should be connected directly to –Vin to ensure proper  
operation. For positive logic models where no control  
signal will be used the ON/OFF pin should be left  
open.  
Product: www.cdpoweronline.com  
6
SLC100 1.2V Rev C 11/2004  

与SLC100-33相关器件

型号 品牌 描述 获取价格 数据表
SLC100-34 CANDD 40 Amp SINGLE OUTPUT QUARTER BRICK DC / DC CONVERTER

获取价格

SLC100-34 MURATA DC-DC Regulated Power Supply Module, 1 Output, 48W, Hybrid

获取价格

SLC100-34 40 Amp Single Output Quarter Brick DC/DC Converter

获取价格

SLC100-35 MURATA DC-DC Regulated Power Supply Module, 1 Output, 48W, Hybrid

获取价格

SLC100-35 CANDD 40 Amp SINGLE OUTPUT QUARTER BRICK DC / DC CONVERTER

获取价格

SLC100-35 40 Amp Single Output Quarter Brick DC/DC Converter

获取价格