SL5162
ELECTRICAL CHARACTERISTICS
TAMB = 125°C (operating range 210°C to180°C), VCC = 15V, (operating range14·5 to15·5V). Max and Min values are
guaranteed by either production test or design. They apply within the specified temperature and supply voltage ranges unless
otherwise stated.
Value
Pin
Units
Characteristic
Conditions
Typ.
Min.
Max.
3, 12
3, 12
19
4·5
5·5
53
V
mA
Supply Voltage
Supply current
Video Input
45
1·0
Vp-p VP = sync to white level, AGC disabled (note 1)
Vp-p VP = sync to white level, AGC enabled
Video input level (VP)
0·5
1·5
1·17
100
V
VC = sync to limit level (note 2)
Eff. white clip level (VC)
Input impedance
Video bandwidth 21 dB
23dB
Video SNR weighted
Differential gain
Differential phase
Line tilt (black level)
Clamp accuracy
Audio Input
k Ω Except for duration of clamp pulse
MHz
MHz
dB
%
deg
%
10
25
60
62
62
62
CCIR Rec 451-1 (note 3), mono sound system
65
65
0·5
5
Dependent upon video input clamp capacitor
mV VP=1·0V D (black level with and without input video)
11
25
k Ω
kHz
Input impedance
Audio bandwidth (21dB)
Subcarrier frequency
FM THD
15
4
7
1·0
MHz Determined by external components.
%
0·5
Indemodulatedsignal.Inputsignal=1kHzsinewave
at 635kHz deviation
13
11
Intercarrier Input
Input level
140
100
0·7
mVp-p To define 222dBC (peak carrier)
mVp-p At device input
FM Performance
Audio input for 100%
deviation (635kHz)
FM deviation sensitivity
Max frequency deviation
kHz/mV Audio input 1kHz sinewave
kHz No pre-emphasis, dependent on external
components
250
11
AM Performance Audio
Modulation depth
Audio SNR (wideband)
RF Output
80
%
Input = 200mVp-p at 1kHz
.46
dB
1, 2
Peak vision carrier:
SECAM (L)
PAL
Flatness band 470-860MHz
APLD
83
84
dBµV VP = 1·0V, sync = 0·3V
dBµV Differential 75Ω output
dB
2
62
%
APL 10-90%
1, 2
1,2
White Level, Nominal
Negative modulation
12
17
22
%
Relative to peak vision carrier (PVC), VP = 1·0V,
all systems (note 4)
Sync Tip
100
6
1
%
%
%
All systems
Negative modulation
Positive modulation
Sync degradation (1ve mod)
S
W
7
3
DSYNC1(16 3 3100)
NOTES
1. This is the nominal input level to provide the preset video modulation index for the selected standard. Any variation from the
nominal level will change the RF modulation index.
2. The actual clip level is set relative to the input video level. The level of 1·17V only applies if the video input signal is correctly
proportioned. The white clip circuit operates only when the AGC is disabled.
3. Measured at CH38 with R&S EMFP demodulator and UAF Video Analyser.
4. Measured at CH21 with R&S EMFP reference demodulator and UAF Video Analyser. Synchronous demodulation.
2