DATA SHEET • SKY74092-11 LNA
Bias Resistor
VCC
VCC
Bias Reference
4-Step
PCS_LNA_IN
CELL_LNA_IN
PCS_LNA_OUT
CELL_LNA_OUT
PCS LNA
+
+
+
+
4-Step
Cell LNA
3-Wire
Serial Bus
VCC
LE
CLK
S323
DATA
Figure 2. SKY74092-11 LNA Block Diagram
(pins 3, 4, and 5, respectively) provide the control inputs. The
SKY74092-11 provides the following control and test registers:
Technical Description
Bias Reference
Mode Selection
Gain Control
Current Selection
LNA bias currents are derived from an on-chip bandgap voltage
reference. The voltage reference requires a 10 k external
resistor.
The SKY74092-11 supports two types of fixed-length data
transfers: 9-bit and 27-bit. Data is latched starting from the
second high-to-low transition on the CLK signal after LE goes
low. The first high-to-low transition of the CLK signal is ignored.
Cellular Band LNA
The cellular band LNA requires an off-chip matching network at
input and output terminals. The LNA is designed to provide a
low Noise Figure (NF) and high 3rd order Input Intercept Point
(IIP3) to achieve the maximum dynamic range.
Package and Handling Information
The cellular LNA has four gain steps to optimize gain, linearity,
and noise at various input signal levels: high gain, mid-gain,
bypass, and high attenuation.
Since the device package is sensitive to moisture absorption, it
is baked and vacuum packed before shipping. Instructions on
the shipping container label regarding exposure to moisture
after the container seal is broken must be followed. Otherwise,
problems related to moisture absorption may occur when the
part is subjected to high temperature during solder assembly.
PCS Band LNA
The PCS band LNA requires an off-chip matching network at
input and output terminals. The PCS LNA is designed to provide
a low NF and high IIP3 to achieve the maximum dynamic range.
The SKY74100 is rated to Moisture Sensitivity Level 3 (MSL3) at
260 C. It can be used for lead or lead-free soldering. For
additional information, refer to the Skyworks Application Note,
PCB Design & SMT Assembly/Rework Guidelines for RFLGA
Packages, document number 103147.
The PCS LNA has four gain steps to optimize gain, linearity, and
noise at various input signal levels: high gain, mid-gain, bypass,
and high attenuation.
Care must be taken when attaching this product, whether it is
done manually or in a production solder reflow environment.
Production quantities of this product are shipped in a standard
tape and reel format.
Serial Interface
A three-wire serial bus is used to control the operation mode,
gain, and current of the LNAs. The CLK, DATA, and LE signals
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
July 23, 2010 • Skyworks Proprietary Information • Products and Product Information Are Subject To Change Without Notice • 103205E
2