Silan
Semiconductors
SC50560
5. Osc illa tion Circ uit
The oscillation circuit may be constructed by connected a
ceramic resonator between the OSCI and OSCO. Please
refer to the diagram right. When the references signal is set
to 455KHz the carrier can be set at 38KHz. When no key
input is pressed, the oscillation circuit is normally stopped,
thereby, lower power dissipation.
SC50560
OSCI OSCO
4
5
Figure 6. Oscillation Circuit
6. CODE FORMAT MODES
SC50560 code format comes in three modes: 001, 002 and 003. Please refer to the diagram below:
Minimum Numbe r of Words
SC50560 Ve rsion
De sc ription
Mode A Code Format:
Tra nsmitte d
SC50560-001
SC50560-002
SC50560-003
Custom Code Bit 5--C5=0,
SEL is connected to VDD
Mode A & B Code Formats
Mode A Code Format:
1 word
3 words
-----
Custom Code Bit 5--C5=1,
When SEL is connected to Vss
Both SC50560-001 and SC50560-002 make use of the same operation when the input from terminal CS and
the scan output (KO0 to KO4) are connected to make the custom code selection with the exception of the number
of word transmitted. Please refer to the table above:
MODE A
The diagram below gives us the transmission code format for Mode A. One Code Word consists of the Leader
Code, 8 bits Custom Code followed by a sync. bit, Separator and 8 bits Data Code followed by another sync. bit.
Please refer to the diagram below.
C0 C1 C2 C3 C4 C5 C6 C7 SYNC
D0 D1 D2 D3 D4 D5 D6 D7 SYNC
Leader Pulse
8 Bits Custom Code
Sync. Bit
Seperator
8 Bits Data Code
Sync. Bit
Figure 7. Mode A Code Format
Each Code Bit may either be “0” or “1”. Please refer to the diagram below.
HANGZHOU SILAN MICROELECTRONICS JOINT-STOCK CO.,LTD
Rev: 2.3
2002-03-21
6