RT1652
Dual Mode (WPC and PMA) 5W Wireless Power Receiver
and Battery Charger
General Description
Features
Wireless Power Receiver Compliant
The RT1652 is a wireless power receiver compliant
with WPC Low Power v1.2 and PMA v2.00 standard.
The RT1652 integrates a synchronous full-bridge
rectifier, a low dropout regulator, and a logic controller
for control and communication. The device receives AC
power from a WPC compatible wireless transmitter and
provides output power up to 5W, which could be used
as a power supply for a charger of mobile or consumer
devices. The RT1652 output can also connect to Li+
battery directly, the direct charge mode features on
running battery charger profile (PreCharge/CC/CV), to
simplify the charging function design and improve the
overall charging efficiency.
WPC Low Power v1.2
PMA v2.00
Battery Charger
Programmable 3V to 12V Out Regulation
Voltage
Integrated Synchronous Rectifier Switch
Support Output Power Up to 5W
High Rectifier Efficiency Up to 96%
High System Efficiency Up to 80%
Programmable Loading for Synchronous
Rectifier Operation
The logic controller can support bi-direction channel
communication including amplitude shift keying (ASK)
modulation for power signal to the transmitter. The
RT1652 provides Foreign Object Detection (FOD)
function to meet the requirement after WPC V1.2. It
communicates with the transmitter for the received
power to determine if a foreign object is present within
the magnetic interface. This provides a higher level of
safety.
Programmable Dynamic Rectifier Voltage
Control for Optimized Transient Response and
Power Efficiency
Highly Accurate Received Power Calculation for
FOD Function
12-bit ADC for Voltage/Current Measurement
Coil Power Loss Modeling for Optimized
Compensation
Adaptive Power Offset Compensation
Embedded Logic Controller
The RT1652 provides a programmable dynamic
rectifier voltage control function to improve power
efficiency, a programmable power management control
for maximum power delivery, a programmable current
limit for suitable load setting, a programmable
temperature setting with external NTC for
thermoregulation, and proper protection functions such
as UVLO, OVP, and OTP.
272B MTP for Programmable
Support Bi-direction Channel Communication
ASK Modulation for Power Signal to Wireless
Power Transmitter
Programmable Temperature Control
Programmable Charge Status Packet (0x05)
Support Alignment with Transmitter
Support Enable, Charge Complete and Fault
Control Inputs
Applications
Cell Phones, Smart Phones, and Headsets
Wireless Power Embedded Battery Packs
Portable Media Players
Receiver Controlled EPT Packet
Over-Current Limit
Over-Voltage Protection
Hand-held Devices
Thermal Shutdown
Wearable Devices
CSP 2.8mm x 2.6mm 36B (Pitch = 0.4mm)
Low Profile (0.5mm Max.)
Copyright © 2018 Richtek Technology Corporation. All rights reserved.
is a registered trademark of Richtek Technology Corporation.
DS1652-00 January 2018
www.richtek.com
1