Reduced
TCO
Easy Adjustment and Reduce works to
Complete Support from Setup to Maintenance
Software
How to Select Required Support Software for Your Controller
The required Support Software depends on the Controller to connect. Please check the following table when purchasing the Support Software.
Omron Machine Automation Controller System
NJ-series
Omron PLC System
CS, CJ, CP, and other series
Item
Controller
G5-series
G5-series
• EtherCAT Communications
• EtherCAT Communications (Unit version 2.1 or later
reccomended)
• EtherCAT Communications Linear Motor
AC Servomotor/Drives
• EtherCAT Communications Linear Motor
• General-purpose input type(PulseTrain or Analog inputs)
• MECHATROLINK-Ⅱ Communications
Automation Software Sysmac Studio
FA Integrated Tool Package CX-One
The Sysmac Studio provides an integrated development
environment to set up, program, debug, and maintain
NJ-series Controllers and other Machine Automation
Controllers, as well as EtherCAT slaves.
Setting, adjustment, monitoring/tracing with the Servo Drive
can be done via an EtherCAT network.
The CX-Drive software allows you to set, transfer, and
compare Servo Drive parameters, to perform trial operation
and adjustments,and to monitor and trace operation.
CX-Drive is bundled in CX-One.
Software
<Connecting method with the Servo Drive>
- Direct connection with the Servo Drive.
- Connection via a PLC (possible with the Servo Drive with
built-in EtherCAT communications function)
<Connecting method with the Servo Drive>
- Connection via the NJ
Simple Gain Adjustment
Quickly adjust the gain using a wizard.
The autotuning feature provided with the CX-Drive makes it easy to adjust the Servo Drive gain. You can use a wizard to complete gain adjustment in
approximately five minutes or less per axis simply by selecting the machine configuration and entering the target set time.
設定画
面イメージ
Setting screen image
Autotuning
Sysmac Studio
CX-Drive
1. Machine Configuration
Although previously the machine configuration was set
using parameters, it can now be selected from ball
screws, turntables, belts, and other devices.
2. Automatic Adjustment
Setting for automatic adjustment and conditions
after completing automatic adjustment.
3. Autotuning
Implement auto-tuning until reaching to a target value.
Stabilization time, overshooting amount and efective
load rate can be monitored.
4. Autotuning Completed
After completing autotuning, the results can be checked
using the data tracing.
Editing Parameters
Simple FFT
• Operation is as easy as with a digital operator.
• Easily set parameters for Inverters and Servo Drives.
• Device frequency characteristics can be easily measured to analyze
resonant frequencies.
• Use notch filters for resonance frequencies to improve response.
Sysmac Studio
CX-Drive
CX-Drive
Sysmac Studio
G5 Series
6
5秒后页面跳转
STM32H743技术深度剖析与应用案例探索
LM321中文资料解析：引脚功能介绍、技术特点、技术特性分析
74HC14芯片资料介绍：性能特性分析、引脚介绍
LM1875芯片手册：功放参数分析、引脚说明、电路设计要点
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
