®
R-GAGE Q120RA-AF2W Sensor
Specifications
Range
Indicators
Power LED: Green (power ON)
The sensor is able to detect a proper object (see Detectable Objects)
from 1 m to 26 m (3.3 ft to 85.3 ft), depending on the target
Signal Strength LED: Red, flashes in proportion to signal strength.
Steady on at 4x excess gain. Only indicates signal amplitude, not
target distance.
Output LEDs: Yellow (output energized) / Red (configuration)
See Overview on page 1
Detectable Objects
Objects containing metal, water, or similar high-dielectric materials
Operating Principle
Frequency modulated continuous-wave (FMCW) radar
Construction
Operating Frequency
Housing: ABS/polycarbonate
Lightpipes: Acrylic
Access Cap: Polyester
US Models: 24.075–24.175 GHz, ISM Band
EU, KR Models: 24.050–24.250 GHz, ISM Band
Maximum Output Power
ERP: 3.3 mW, 5 dBm
Connections
Integral 5-wire 2 m (6.5 ft) cable or M12 Euro-style QD fitting. QD
models require a mating cordset
EIRP: 100 mW, 20 dBm
Supply Voltage
Output Configuration
US and EU models: 12 to 30 V dc, less than 100 mA, exclusive of load
KR models: 12 to 24 V dc, less than 100 mA exclusive of load
DIP switch A8 selects Dual NPN (default) or PNP; DIP switch B7 selects
N.O. (default) or N.C. operation; 150mA each
· Zone 1 output: white wire
Supply Protection Circuitry
· Zone 2 output: black wire
Protected against reverse polarity and transient overvoltages
Operating Temperature
Delay at Power-up
– 40° to + 65° C (– 40° to + 149° F)
Less than 2 seconds
Environmental Rating
Output Protection
IP67
Protected against short circuit conditions
Certifications
Response Time
DIP-switch-configurable ON/OFF response time
; ETSI/EN 300 440; FCC part 15; ANATEL Category II; KC mark -
MSIP/RRA; CMIIT Category G; ARIB STD T-73; for others, contact
Banner Engineering
Adjustments
DIP-switch-configurable sensing distance, sensitivity, response time,
and output configuration
Country of Origin: USA
FCC ID: UE3Q120RAUS—This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Este equipamento opera em caráter secundário, isto é, não tem direito à
proteção contra interferência prejudicial, mesmo de estações do mesmo
tipo e não pode causar interferência a sistemas operando em caráter
primário.
Dimensions
All measurements are listed in millimeters, unless noted otherwise.
50.75
4X
5
Mounting holes
Indicator LEDs
159.5
140.79
Cover for DIP switch
M12/Euro-style QD
6.5
90.8
62
P/N 189332 Rev. C
www.bannerengineering.com - Tel: +1-763-544-3164
5