3 Disassembly and Reassembly
3-1-7 Removing the Video PCB Assembly
Rear Shield and Video PCB
3-1-9 Removing the Main PCB
1. Remove 6 screws on the main PCB.
1. Remove the 3 screws on the PCB Assembly.
2. Pull the Main PCB towards you and carefully
lift out the main PCB and placet it on a flat,
level surface that is protected from static
electricity.
2. Remove the Video PCB Assembly Rear Shield.
(5 point)
3. Lift out the Video PCB and pleat it on a flat,
level surface that is protected from static
electricity.
3-1-10 Removing the Bracket
1. Remove the 10 screws on the Front Cabinet.
3-1-8 Removing the Main PCB Assembly
1. Remove both side screws (4 screws) on the
lower edge of the CRT Bracket.
3-1-11 Removing the Degaussing Coil
2. Remove Chassis Ground Wire on the both
side.
1. Using pinch-nosed pliers or long-nosed pliers,
carefully push the 4 plastic ties on the Bracket.
3. Disconnect CN201, CN409, CN601, H_DY,
CN604 and Anode Cap on the Main PCB
Assembly.
2. Lift the Degaussing Coil Assembly from the
Bracket.
3-2 Reassembly
Reassembly procedures are in the reverse order of Disassembly procedures.
3-2
PG17**/PG19**/PG21**