MT9D115
MT9D115 1/5‐inch
System‐On‐a‐Chip (SOC)
CMOS Digital Image Sensor
www.onsemi.com
Table 1. KEY PERFORMANCE PARAMETERS
Parameter
Typical Value
1.75 mm × 1.75 mm
ORDERING INFORMATION
See detailed ordering and shipping information on page 2 of
this data sheet.
Pixel Size
Optical Format
1/5-inch
Array Format (Active)
Imaging Area
1600 (H) × 1200 (V) = 1.92 Mp
• Automatic Functions: Exposure, White
Balance, Black Level Offset Correction,
Flicker Detection and Avoidance, Color
Saturation Control, Defect Identification and
Correction, Aperture Correction, and GPIO
• Programmable Controls: Exposure, White
Balance, Horizontal and Vertical Blanking,
Color, Sharpness, Gamma, Lens Shading
Correction, Horizontal and Vertical Image
Flip, Zoom, Windowing, Sampling Rates,
and GPIO
2.8 mm × 2.10 mm,
3.50 mm Diagonal (4:3 Aspect Ratio)
CRA
25°
Color Filter Array
Scan Mode
RGB Bayer
Progressive
Shutter
Electronic Rolling Shutter (ERS)
6–54 MHz
Input Clock Range
Output Pixel Clock Maximum
Output MIPI Data Rate Maximum
Max. Frame Rate
85 MHz
512 Mb/s
• 15 Frames per Second (fps) at
15 fps Full Res
30 fps 800 x 600
1600(H) × 1200 (V) with Moderate Pixel
Clock Frequency (≤ 64 MHz) to Minimize
Baseband Reception Interference and 30 fps
at 800 (H) × 600 (V)
Responsivity
0.65 V/Lux−sec (550 nm)
39 dB (MAX)
Signal-to-Noise Ratio
Dynamic Range
63.9 dB (Pixel)
• 2 × 2 Pixel Binning to Improve Low-light
Supply Voltage
Digital
Analog
I/O
Image Quality
1.8 V (Nominal)
2.8 V (Nominal)
1.8 V or 2.8 V (Nominal)
1.7−1.95 V
• Support for External LED or Xenon Flash
• On-chip Phase-locked Loop (PLL) to
Minimize the Number of System Clocks
• Low Power Modes to Prolong Battery Life
of Portable Devices
MIPI
Power Consumption
Operating Temperature Range
Package
196 mW (Note 1)
–30°C to 70°C (at Junction)
Bare Die, CSP
• Fail-safe I/Os with Programmable Output
Slew Rate
1. Power consumption for typical voltages at 800 × 600 video mode.
• Industry Standard Two-wire Serial Interface
for Controls
• 10-bit Parallel or MIPI Serial Interfaces for
Image Data
Features
• 2 Mp Resolution (1600 (H) × 1200 (V))
• 1/5-inch Optical Format
• Same or Better Image Quality Compared to MT9D112
• Individual Module ID Support Through One-time Programmable
Applications
• Cellular Phones
• PC Cameras
• PDAs
(OTP) Memory
• Surface Fit Lens Correction (LC) to Compensate for Lens/Small
Pixel Vignetting and Corner Color Variations
© Semiconductor Components Industries, LLC, 2010
1
Publication Order Number:
January, 2017 − Rev. 5
MT9D115/D