Datasheet > 电信电路 > 调制解调器> MSM7586-01TS-K

MSM7586-01TS-K

更新时间： 2024-02-12 15:09:05

品牌	Logo	应用领域
冲电气 - OKI		解码器调制解调器编解码器 PC
页数	文件大小	规格书
42页	281K
描述
Modem, 384kbps Data, CMOS, PQFP100, PLASTIC, TQFP-100

阅读下载

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

MSM7586-01TS-K 技术参数

生命周期：	Obsolete	零件包装代码：	QFP
包装说明：	TFQFP,	针数：	100
Reach Compliance Code：	unknown	HTS代码：	8542.39.00.01
风险等级：	5.82	Is Samacsys：	N
数据速率：	384 Mbps	JESD-30 代码：	S-PQFP-G100
长度：	14 mm	功能数量：	1
端子数量：	100	最高工作温度：	70 °C
最低工作温度：	-25 °C	封装主体材料：	PLASTIC/EPOXY
封装代码：	TFQFP	封装形状：	SQUARE
封装形式：	FLATPACK, THIN PROFILE, FINE PITCH	认证状态：	Not Qualified
座面最大高度：	1.2 mm	标称供电电压：	3 V
表面贴装：	YES	技术：	CMOS
电信集成电路类型：	MODEM	温度等级：	OTHER
端子形式：	GULL WING	端子节距：	0.5 mm
端子位置：	QUAD	宽度：	14 mm
Base Number Matches：	1

MSM7586-01TS-K 数据手册

¡ Semiconductor

MSM7586-01/03

AFC

AFC operation range specification signal input.

As shown in Fig. 4, the AFC information is reset when both AFC and RPR are set to "1". AFC

operation starts after a fixed number of clock cycles and the AFC information is reset. If RPR is

set to "1", an average number of times that AFC turns on is low. If RPR is "0", AFC is high. If AFC

is "0", frequency error is not calculated, but the frequency is corrected using an error that is held.

RCW

Clock recovery circuit operation ON/OFF control signal input.

If RCW this pin is "0", DPLL does not make any phase corrections.

(CASE1)

AFC

RPR

Average number of times

AFC is high.

AFC information Average

is reset. number of times

AFC is low.

AFC information

is maintained.

(CASE2)

AFC

"0"

Average number of times

RPR

The clock recovery circuit

starts with the previous

AFC information.

AFC information

is maintained.

AFC is high.

Figure 4 AFC Control Timing Diagram

DENM , EXCKM, DINM, DOUTM

Serial control ports for the microprocessor interface.

The device contains a 6-byte control register (CRM0 - 5). An external CPU uses these pins to read

data from and write data to the control register. DENM is the "Enable" signal input pin. EXCKM

is a data shift clock pulse input pin. DINM is an address and data input pin. DOUTM is a data

output pin. Figure 5 shows input/output timing diagram.

10/42

1...7 8 91011 12 13...42

下载PDF

与MSM7586-01TS-K相关器件

型号	品牌	描述	获取价格	数据表
MSM7586-03	OKI	pie/4 Shift QPSK MODEM/ADPCM CODEC	获取价格
MSM7586-XX	OKI	pie/4 Shift QPSK MODEM/ADPCM CODEC	获取价格
MSM7590	OKI	5V Sinlge-Rail ADPCM CODECs	获取价格
MSM7590L-01	OKI	Multi-Function ADPCM CODEC	获取价格
MSM7590L-01TS-K	OKI	ADPCM Codec, A/MU-Law, 1-Func, PDSO32, 8 X 14 MM, 0.50 MM PITCH, PLASTIC, TSOP1-32	获取价格
MSM7590-TS-K-01	OKI	ADPCM Codec, A-Law, 1-Func, CMOS, PDSO32, TSOP1-32	获取价格