5秒后页面跳转
捷配首页

Datasheet > MAX9963
MAX9963 PDF预览

MAX9963

更新时间： 2023-12-20 18:45:07
品牌 Logo 应用领域
亚德诺 - ADI 驱动比较器驱动器
页数 文件大小 规格书
25页 746K
描述
四通道、低功耗、500Mbps ATE驱动器/比较器

阅读下载

中文翻译

获取价格

MAX9963 数据手册

 浏览型号MAX9963的Datasheet PDF文件第2页浏览型号MAX9963的Datasheet PDF文件第3页浏览型号MAX9963的Datasheet PDF文件第4页浏览型号MAX9963的Datasheet PDF文件第5页浏览型号MAX9963的Datasheet PDF文件第6页浏览型号MAX9963的Datasheet PDF文件第7页 
19-2977; Rev 1; 1/04  
Quad, Low-Power, 500Mbps  
ATE Driver/Comparator  
General Description  
Features  
The MAX9963/MAX9964 four-channel, low-power, high-  
speed pin electronics driver and comparator ICs  
include, for each channel, a three-level pin driver, a dual  
comparator, and variable clamps. The driver features a  
wide voltage range and high-speed operation, includes  
high-Z and active-termination (3rd-level drive) modes,  
and is highly linear even at low-voltage swings. The dual  
comparator provides low dispersion (timing variation)  
over a wide variety of input conditions. The clamps pro-  
vide damping of high-speed DUT waveforms when the  
device is configured as a high-impedance receiver.  
High-speed, differential control inputs compatible with  
ECL, LVPECL, LVDS, and GTL levels are provided for  
each channel. ECL/LVPECL or flexible open-collector  
outputs are available for the comparators.  
♦ Small Footprint—Four Channels in 0.4in2  
♦ Low Power Dissipation: 825mW/Channel (typ)  
♦ High Speed: 500Mbps at 3VP-P  
♦ Low Timing Dispersion  
♦ Wide -1.5V to +6.5V Operating Range  
♦ Active Termination (3rd-Level Drive)  
♦ Low-Leakage Mode: 15nA (max)  
♦ Integrated Clamps  
♦ Interface Easily with Most Logic Families  
♦ Digitally Programmable Slew Rate  
♦ Internal Logic Termination Resistors  
♦ Low Gain and Offset Error  
The A-grade version provides tight matching of gain  
and offset for the drivers and comparators, allowing ref-  
erence levels to be shared across multiple channels in  
cost-sensitive systems. For system designs that incor-  
porate independent reference levels for each channel,  
the B-grade version is available at reduced cost.  
Ordering Information  
PART  
TEMP RANGE  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
PIN-PACKAGE  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EPR  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
100 TQFP-EP**  
MAX9963ADCCQ*  
MAX9963AKCCQ*  
MAX9963AGCCQ*  
MAX9963AHCCQ*  
MAX9963AJCCQ  
MAX9963BDCCQ*  
MAX9963BKCCQ*  
MAX9963BGCCQ  
MAX9963BHCCQ*  
MAX9963BJCCQ*  
MAX9964ADCCQ*  
MAX9964AKCCQ*  
MAX9964AGCCQ*  
MAX9964AHCCQ*  
MAX9964AJCCQ*  
MAX9964BDCCQ*  
MAX9964BKCCQ*  
MAX9964BGCCQ  
MAX9964BHCCQ*  
MAX9964BJCCQ*  
Optional internal resistors at the high-speed inputs pro-  
vide differential termination of LVDS inputs, while  
optional internal resistors provide the pullup voltage  
and source termination for open-collector comparator  
outputs. These features significantly reduce the dis-  
crete component count on the circuit board.  
Low-leakage, slew rate, and tri-state/terminate controls  
are operational configurations that are programmed  
through a 3-wire, low-voltage, CMOS-compatible serial  
interface.  
The MAX9963/MAX9964 operating range is -1.5V to  
+6.5V, with power dissipation of only 825mW per channel.  
These devices are available in a 100-pin, 14mm x  
14mm body, 0.5mm pitch TQFP with an exposed 8mm  
x 8mm die pad on the top (MAX9963) or bottom  
(MAX9964) of the package for efficient heat removal.  
The MAX9963/MAX9964 are specified to operate with  
an internal die temperature of +70°C to +100°C, and  
feature a die temperature monitor output.  
Applications  
Flash Memory Testers  
*Future product—contact factory for availability.  
**EP = Exposed pad.  
Commodity DRAM Testers  
Low-Cost Mixed-Signal/System-on-Chip Testers  
Active Burn-In Systems  
Pin Configurations appear at end of data sheet.  
Selector Guide appears at end of data sheet.  
Structural Testers  
________________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at  
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.  
1234567...25

中文翻译

下载PDF

与MAX9963相关器件

型号 品牌 获取价格 描述 数据表
MAX9963ADCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator
MAX9963AGCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator
MAX9963AGCCQ+TD MAXIM

获取价格

 		Comparator, 4 Func, 15000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM,
MAX9963AHCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator
MAX9963AJCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator
MAX9963AJCCQ+D MAXIM

获取价格

 		Comparator, 4 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9963AJCCQ-D MAXIM

获取价格

 		Comparator, 4 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9963AKCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator
MAX9963BDCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator
MAX9963BGCCQ MAXIM

获取价格

 		Quad, Low-Power, 500Mbps ATE Driver/Comparator

与MAX9963相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证