5秒后页面跳转
MAX22519 PDF预览

MAX22519

更新时间: 2024-10-04 02:52:47
品牌 Logo 应用领域
美信 - MAXIM /
页数 文件大小 规格书
13页 2165K
描述
MAX22518 Evaluation Kit Evaluate: MAX22517‒MAX22519

MAX22519 数据手册

 浏览型号MAX22519的Datasheet PDF文件第2页浏览型号MAX22519的Datasheet PDF文件第3页浏览型号MAX22519的Datasheet PDF文件第4页浏览型号MAX22519的Datasheet PDF文件第5页浏览型号MAX22519的Datasheet PDF文件第6页浏览型号MAX22519的Datasheet PDF文件第7页 
Click here to ask about the production status of specific part numbers.  
MAX22518 Evaluation Kit  
Evaluate: MAX22517‒MAX22519  
General Description  
Features  
The MAX22518 evaluation kit (EV kit) provides a proven  
design to evaluate the MAX22517–MAX22519 family of  
Self-Generated Isolated Field-Side Supply V  
DDF  
2 Unidirectional Channels with Input Charge Pumps  
(MAX22517 and MAX22518) and Open-Drain  
Outputs (MAX22518 and MAX22519)  
self-powered, dual-channel, 3.5kV  
digital isolators.  
RMS  
The EV kit allows easy access to both channels through  
either terminal blocks or test points. The isolated field-side  
Surge and Short Protection with Onboard  
supply V  
can also be accessed using the test points.  
DDF  
Components  
• 24VAC Short Protection  
• ±1kV Line-to-Ground and ±2kV Line-to-Line Surge  
Tolerance (1.2/50μs Waveform)  
The EV kit includes necessary external components to  
demonstrate the device’s surge performance (1.2/50μs)  
up to ±1kV between input and field ground (differential),  
or up to ±2kV between inputs (common mode).  
Terminal Blocks and Test Points for Easy Connection  
The MAX22518 EV kit is designed to support all three  
variants in the MAX22517–MAX22519 family. Jumpers  
on the logic-side outputs (OUT1L and OUT2L) allow to  
connect or disconnect the pullup resistors, depending  
on whether U1 has open-drain or push-pull outputs. The  
evaluation board comes with the wide-body 8-pin SOIC  
package type with 5.5mm creepage and clearance. See  
Table 1 for EV kit details.  
to External Equipment  
Single Logic-Side Supply V  
, Range from 3V  
DDL  
to 5.5V  
Guaranteed Up to 3.5kV  
Isolation for 60s  
RMS  
-40°C to +125°C Temperature Range  
Proven PCB Layout  
The MAX22518 EV kit (MAX22518EVKIT#) is fully  
assembled and tested, and comes populated with the  
MAX22518AWA+ (Figure 1). The board also supports the  
MAX22517AWA+ and MAX22519AWA+, but requires the  
user to replace U1. See Table 1 and Evaluate MAX22517  
and MAX22519 on MAX22518EVKIT# section for details.  
Ordering Information appears at end of data sheet.  
The EV kit is powered from a single power supply on the  
logic side, V  
, in range from 3V to 5.5V. The field-side  
DDL  
supply, V  
is generated by the device and has a nomi-  
DDF,  
nal voltage of 3.3V. The logic-side ground (GNDL) and  
field-side ground (GNDF) are isolated and can have con-  
tinuous working voltage difference up to 445V  
. For  
RMS  
evaluating the electrical parameters of the devices without  
any isolation between the two sides, a common ground  
can be shared between GNDL and GNDF.  
Note: When ordering an EV kit, if the desired device is  
not the MAX22518AWA+, request samples of the desired  
MAX22517–MAX22519 IC that can be soldered to the PCB.  
319-100553; Rev 2; 8/20  

与MAX22519相关器件

型号 品牌 获取价格 描述 数据表
MAX22519AWA+ MAXIM

获取价格

Self-Powered, 2-Channel, 3.5kVRMS Digital Isolator
MAX2251EBE MAXIM

获取价格

Amplifier. Other
MAX2251EVKIT MAXIM

获取价格

Evaluation Kit for the MAX2470/MAX2471[MAX2470EVKIT/MAX2471EVKIT ]
MAX22520 ADI

获取价格

一次性可编程(OTP)工业传感器输出驱动器
MAX22530 MAXIM

获取价格

Easy Evaluation of MAX22530/MAX22531
MAX22530 ADI

获取价格

现场端自供电4通道12位隔离式ADC
MAX22530EVKIT MAXIM

获取价格

Easy Evaluation of MAX22530/MAX22531
MAX22531 MAXIM

获取价格

Easy Evaluation of MAX22530/MAX22531
MAX22531 ADI

获取价格

现场端自供电4通道12位隔离式ADC
MAX22532 MAXIM

获取价格

Field-Side Self-Powered, 4-Channel, 12-bit, Isolated ADC