MITSUBISHI ICs (Monitor)
M52347SP/FP
SYNC SIGNAL PROCESSOR
7
8
when COMP/H only is input or when both COMP/H and GREEN
are input.
3) Polarity detection and non-input detection (pins
and
)
External capacitance is required as a filter pin to detect polarity
and non-input. As the value is larger, the ripple is smaller and
less malfunction occurs. However, the response speed for
detection is lower. A sufficient external capacitance is 0.05 µF
with input of 15 kHz and 10 uF with input of 60 kHz. However,
check the frequency of the input signal in use and the filter pin
waveform with the duty ratio conditions, and then check that the
value is 3.1V or more (2.8V in capability) with positive polarity
input and 1.9V or less (2.2V in capability) with negative polarity
input.
8
6
4
R=10kΩ
2
11
4) V S/S IN (pin
)
R=4.3kΩ
Input a signal of having externally integrated composite sync for
V sync separation.
0
10
100
1000
6
12
12
Composite sync input into pin
is output to pin . Output at
Clamp Timing Capacitance at Pin
(pF)
20
11
is externally integrated and is input into pin
for V sync
11
separation. With the waveform at pin
element has been fully dropped.
, check that the H
3. Sampling Pulse from VD Portion
The threshold levels of sync separation, given hysteresis, are
3.5V and 1.8V.
10
V TIME GATE SW (Pin
)
14
15
Whether to output the pulse of VD portion from pins
and
10
can be selected. When pin
portion is output. When pin
is not output.
is "H" or OPEN, pulse of the VD
is "L", the pulse of the VD portion
Input waveform at
10
pin
6
Waveform at
pin
11
VTH=3.5V
VTH=1.8V
14
Output at pin
when the pin 10 is "H" or OPEN
Output waveform at
pin
13
2. Clamp Pulse
VD portion
1) Clamp pulse width
20
CLAMP TIMING (Pin
)
The clamp pulse width is determined by the external resistance
and the capacitance. As the resistance value and capacitance
value are larger, the clamp pulse width is wider.
Output at pin
when pin
is "L"
14
10
10
Output at pin 15 when pin
is "H" or OPEN
The time constant is determined by the current flowing out of pin
20
and the capacitance value of the timing pin. The flow current
20
at pin
is determined by the pin voltage and external resistance
value. When the external resistance is 4.3 Ω (that is 700 uA) and
VD portion
the external capacitance is 220 pF, the pulse width is 0.4 usec.
2) Clamp pulse position
3
CLAMP SW (pin
)
Output at pin
when pin
is "L"
10
15
3
When pin
is "M" or "L", fixing a higher-priority signal to the
trailing edge results in occurrence of a clamp pulse. When pin 3
is 'H", and only GREEN is input, clamp pulse occurs at the
trailing edge. A clamp pulse also occurs at the leading edge
11