Product Specification
Table 1-4.
Symbol
tr
AC Characteristics
Parameter
Conditions
Min.
Typ.
Max.
Units.
(3)
Modulation output rise time
20% to 80% into 25 Ω . For I
from 3 mA
–
67
80
ps
MOD
to 30 mA. Measured using 11110000 pattern
at 2.5Gbps.
tf
Modulation output fall time
–
67
1
80
2
ps
%
OS
Overshoot of modulation output
current in the “off” direction
into 25 Ω load
--
OFF
RJ
DJ
Random jitter
–
0.8
10
–
ps
rms
Deterministic jitter
K28.5 pattern at 4.3 Gbps
23
ps
pp
(includes pulse width distortion)
Notes:
1. Minimum voltage at OUT+ > 0.7V.
2. The current through the laser in this state can be made negligible by adding a 1kΩ or less resistor in parallel with the laser.
3. The M02069 is designed to drive 25Ω loads. External resistance should be added in series or parallel to the Laser to create this load impedance. In
common cathode mode, 50Ω resistors internal to the M02069 are in parallel with the laser..
1.5
Safety Logic Timing
(VCC = 3.05 V to 3.55V or 4.7V to 5.5V, TA = -40 °C to +95 °C, unless otherwise noted)
Typical values for common anode are at VCC = 3.3 V, IBOUTCA = 20 mA, IMOD = 20 mA, TA = 25 °C, unless otherwise noted.
Typical values for common cathode are at VCC = 3.3 V, IBOUTCC = 5 mA, IMOD = 5 mA, TA = 25 °C, unless otherwise noted.
Table 1-5.
Symbol
t_off
Safety Logic Timing
Parameter
Conditions
Min.
Typ.
Max.
Units.
DIS assert time
Rising edge of DIS to fall of output signal
10
µs
(1)
below 10% of nominal
t_on
DIS negate time
Falling edge of DIS to rise of output signal
above 90% of nominal
1
5
ms
ms
(1)
(2)
t_init
Time to initialize
Includes reset of FAIL; from power on after
Supply_OK or from negation of DIS during
reset of FAIL condition
2
3
t_fault
t_reset
Laser fault time - from fault condition From occurrence of fault condition or when
100
µs
µs
ns
ns
to assertion of FAIL
Supply_OK is beyond specified range
(3)
DIS time to start reset
DIS or ENA pulse width required to initialize
safety circuitry or reset a latched fault
10
t_on
DIS negate (turn-on) time during
burst-mode operation
Using integrated switch at SVCC (3.3V
operation)
300
200
500
500
BM
BM
(4)
t_off
DIS assert (turn-off) time during
burst-mode operation
Using integrated switch at SVCC (3.3V
operation)
(4)
Notes:
1. With CAPC = 2.2nF
2. User-adjustable. Specifications reflect timing with no external RESET capacitor.
3. With < 1nF capacitor from RESET pin to ground.
4. Imod > 12mA
02069-DSH-001-D
Mindspeed Technologies™
Mindspeed Proprietary and Confidential
7