2.0 Pin Definitions
Table 2-1.
QSOP Pin#
1
Pin Descriptions
Name
Function
ST
Loss of signal threshold setting input. Connect a 1% resistor between this pin and V
threshold.
(pin 2) to set loss of signal
CC3
SET
2
V
Power supply input for 3.3V applications or the output of the internally regulated 3.3V voltage when V = 5V.
CC3
CC
Connect directly to supply for 3.3V applications (internal regulator not in use). Do not connect to power supply if
V
= 5V.
CC
3
4
5
6
7
GND
DINP
DINN
NC
Ground.
Non-inverting data input. Internally terminated with 50Ω to V (see Figure 3-2).
TT
Inverting data input. Internally terminated with 50Ω to V (see Figure 3-2).
TT
No Connect. Leave Floating.
V
Power supply input for 3.3V applications or the output of the internally regulated 3.3V voltage when V = 5V.
CC3
CC
Connect directly to supply for 3.3V applications (internal regulator not in use). Do not connect to power supply if
V
= 5V.
CC
8
JAM
Output disable. When high, data outputs are disabled (with non-inverting output held high and inverting output
held low). Connect to LOS output to disable outputs with loss of signal. Outputs are enabled when JAM is low or
floating. Internal 150 kΩ resistor to ground.
9
LOS
ST
Loss of signal output. Goes high when input signal falls below threshold set by ST . This output is an open
SET
collector TTL with internal 80 kΩ pull-up resistor to V . Leave floating if not used.
CC
10
Signal detect output. Goes high when input signal amplitude is above threshold set by ST . In M02044, this
SET
output is an open collector TTL with internal 80 kΩ pull-up resistor to V . Leave floating if not used.
CC
11
12
13
14
GND
Ground.
PECLN
PECLP
Inverting data output (PECL).
Non-inverting data output (PECL).
Power supply. Connect to either +5V or +3.3V.
V
CC
15
16
NC
No Connect. Leave Floating.
I
Internal reference current for the LOS threshold. Must be connected to ground through a 12.1 kΩ 1% resistor.
REF
02044-DSH-002-A
Mindspeed Technologies™
Mindspeed Proprietary and Confidential
5