LTC3374
ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the full operating
junction temperature range, otherwise specifications are at TA = 25°C (Note 2). VCC = VIN1-8 = 3.3V, unless otherwise specified.
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
Interface Logic Pins (PBGOOD_ALL, MODE)
I
Output High Leakage Current
Output Low Voltage
PGOOD_ALL 5.5V at Pin
PGOOD_ALL 3mA into Pin
MODE
–1
1
µA
V
OH
V
V
V
0.1
0.4
OL
IH
IL
l
l
Input High Threshold
Input Low Threshold
1.2
V
MODE
0.4
V
Interface Logic Pins (EN1, EN2, EN3, EN4, EN5, EN6, EN7, EN8)
l
l
V
V
V
Enable Rising Threshold
Enable Falling Hysteresis
Enable Rising Threshold
Enable Pin Leakage Current
All Regulators Disabled
400
730
60
1200
mV
mV
mV
µA
HI_ALLOFF
EN_HYS
HI
At Least One Regulator Enabled
380
–1
400
420
1
I
EN
EN = V = V = 5.5V
CC IN
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 3: The LTC3374 includes overtemperature protection which protects
the device during momentary overload conditions. Junction temperatures
will exceed 150°C when overtemperature protection is active. Continuous
operation above the specified maximum operating junction temperature
may impair device reliability.
Note 2: The LTC3374 is tested under pulsed load conditions such that
T ≈ T . The LTC3374E is guaranteed to meet specifications from
Note 4: Static current, switches not switching. Actual current may be
higher due to gate charge losses at the switching frequency.
Note 5: The current limit features of this part are intended to protect the
IC from short term or intermittent fault conditions. Continuous operation
above the maximum specified pin current rating may result in device
degradation over time.
J
A
0°C to 85°C junction temperature. Specifications over the –40°C to
125°C operating junction temperature range are assured by design,
characterization and correlation with statistical process controls. The
LTC3374I is guaranteed over the –40°C to 125°C operating junction
temperature range and the LTC3374H is guaranteed over the –40°C to
150°C operating junction temperature range. High junction temperatures
degrade operating lifetimes; operating lifetime is derated for junction
temperatures greater than 125°C. Note that the maximum ambient
temperature consistent with these specifications is determined by
specific operating conditions in conjunction with board layout, the rated
package thermal impedance and other environmental factors. The junction
temperature (T in °C) is calculated from ambient temperature (T in °C)
J
A
and power dissipation (P in Watts) according to the formula:
D
T = T + (P • θ )
JA
J
A
D
where θ (in °C/W) is the package thermal impedance.
JA
3374f
5
For more information www.linear.com/LTC3374