Spec No.: JELF243C_0015V-01
P7/14
No.
Item
Specification
Test method
8.3 Vibration
Appearance shall have no significant
mechanical damage.
Oscillation frequency: 10 Hz to 2000 Hz to 10 Hz, for
approx. 20 min
Inductance change rate: within ±10%
Total amplitude: total amplitude of 1.5 mm or
acceleration amplitude of 196 m/s2, whichever is
smaller
Test time: 3 directions perpendicular to each other, 2 h
for each direction (6 h in total)
8.4 Solderability
90% or more of the outer electrode shall Flux: immersed in ethanol solution with a rosin content
be covered with new solder seamlessly. of 25(wt)% for 5 s to 10 s
Solder: Sn-3.0Ag-0.5Cu solder
Pre-heating: 150°C±10°C/60 s to 90 s
Solder temperature: 240°C±5°C
Immersion time: 3 s±1 s
8.5 Resistance to
soldering heat
Appearance: No significant mechanical Flux: immersed in ethanol solution with a rosin content
damage shall be observed.
of 25(wt)% for 5 s to 10 s
Inductance change rate: within ±10%
Solder: Sn-3.0Ag-0.5Cu solder
Pre-heating: 150°C±10°C/60 s to 90 s
Solder temperature: 260°C±5°C
Immersion time: 5 s±1 s
Post-treatment: left at a room condition for 24 h±2 h
9. Environmental Performance
The product is soldered on a glass-epoxy substrate for test.
No.
Item
Specification
Test method
9.1 Heat resistance
9.2 Cold resistance
9.3 Humidity
Appearance: No significant mechanical Temperature: 125°C±2°C
damage shall be observed.
Test time: 1000 h (+48 h, -0 h)
Inductance change rate: within ±10%
Post-treatment: left at a room condition for 24 h±2 h
Appearance: No significant mechanical Temperature: -55°C±3°C
damage shall be observed.
Test time: 1000 h (+48 h, -0 h)
Inductance change rate: within ±10%
Post-treatment: left at a room condition for 24 h±2 h
Appearance: No significant mechanical Temperature: 40°C±2°C
damage shall be observed.
Humidity: 90% (RH) to 95% (RH)
Inductance change rate: within ±10%
Test time: 1000 h (+48 h, -0 h)
Post-treatment: left at a room condition for 24 h±2 h
9.4 Temperature cycle
Appearance: No significant mechanical Single cycle conditions:
damage shall be observed.
Step 1: -55°C±2°C/30 min±3 min
Inductance change rate: within ±10%
Step 2: ordinary temperature/10 min to 15 min
Step 3: +125°C±2°C/30 min±3 min
Step 4: ordinary temperature/10 min to 15 min
Number of testing: 10 cycles
Post-treatment: left at a room condition for 24 h±2 h
10. Specification of Packaging
10.1 Appearance and dimensions of tape (8 mm width/paper tape)
A
B
t
0.35±0.03
0N6 to 62N、R13 to R27:0.67±0.03
68N to R12:0.65±0.03
0.55 max.
(in mm)
MURATA MFG CO., LTD