20W Single Output Switching Power Supply
LPC-20 series
Features :
Constant current design
Universal AC input / Full range
Withstand 300VAC surge input for 5 seconds
Protections: Short circuit / Over voltage
Cooling by free air convection
Small and compact size
Fully encapsulated with IP67 level (Note.7)
Fully isolated plastic case
Class
power unit, no FG
Class 2 power unit
Pass LPS
Suitable for LED lighting and moving sign applications
100% full load burn-in test
Low cost, high reliability
2 years warranty
IP67
( for 350mA only)
( except for 350mA )
LPS
SPECIFICATION
MODEL
LPC-20-350
LPC-20-700
RATED CURRENT
350mA
9 ~ 48V
16.8W
700mA
9 ~ 30V
21W
DC VOLTAGE RANGE
RATED POWER
RIPPLE & NOISE (max.) Note.2 200mVp-p
VOLTAGE TOLERANCE Note.3 5.0%
200mVp-p
OUTPUT
CURRENT ACCURACY
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
HOLD UP TIME (Typ.)
VOLTAGE RANGE
5.0%
1.0%
2.0%
Note.6 500ms, 250ms / 230VAC 500ms, 250ms / 115VAC at full load
50ms/230VAC
Note.4 90 ~ 264VAC
47 ~ 63Hz
16ms/115VAC at full load
127 ~ 370VDC
FREQUENCY RANGE
EFFICIENCY (Typ.)
AC CURRENT (Typ.)
83%
INPUT
0.55A/115VAC 0.35A/230VAC
INRUSH CURRENT(max.)
LEAKAGE CURRENT
COLD START 35A/115VAC
0.25mA / 240VAC
50.4 ~ 60V
70A/230VAC
31.5 ~ 40.5V
PROTECTION
ENVIRONMENT
OVER VOLTAGE
Protection type : Shut off o/p voltage, clamping by zener diode
-30~ +70 (Refer to "Derating Curve")
20 ~ 90% RH non-condensing
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
-40 ~ +80 , 10 ~ 95% RH
0.03%/ (0 ~ 50
)
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
UL879, UL1310 , CSA C22.2 No. 207-M89(except for LPC-20-350), CAN/CSA C22.2 No. 223-M91(except for LPC-20-350),
IP67 approved ; design refer to TUV EN60950-1
SAFETY STANDARDS
SAFETY &
EMC
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
EMC EMISSION
EMC IMMUNITY
MTBF
I/P-O/P:3KVAC
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH
Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
786.5Khrs min. MIL-HDBK-217F (25
118*35*26mm (L*W*H)
)
OTHERS
NOTE
DIMENSION
0.22Kg; 60pcs/14.2Kg/0.62CUFT
PACKING
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
7. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
File Name:LPC-20-SPEC 2012-03-20