MECHANICAL DIMENSIONS
11.7” x 1.498” x 0.585”
(297.18mm x 38.05mm x 14.86mm)
Mounting hole spacing = 3.22” (81.8mm)
Max screw size #8
Total length for “Z” units connected end to end =
(Z x 11.7) - ((Z-1) x 0.25) (inches)
(Z x 297.2) - ((Z-1) x 6.35) (mm)
Side View
Top View
Dimensions in mm
Example: 2 units total length = 23.15” (588.01)
ASSEMBLY INFORMATION
1) Position ‘tab’ end of first powerwhite module
by input wires/driver. (Do not connect power
to entry cable before completing steps 2-6)
2) Remove cover from module (Do not
remove mask). Modules may be screwed
down onto surface by inserting two M6 or 8/32
flathead screws through screw holes.
3) Insert 6 pin prong from LML6-CON-CAB
entry cable into 6 prong receptacle near tab
end of first module.
4) Insert 4 pin prong from connector cable into
‘notch’ end of module, insert 6 pin prong from
connector cable into ‘tab’ end of next module
(repeat for each additional module).
5) Connector cable wires can be routed
through interior of modules by placing them
into interior wire holders.
6) Insert LML6-TER-CAB 4-pin terminal prong
into ‘notch’ end of last module in run
(required).
INPUT WIRE CHART
7) Replace covers and connect power to
LM60-CON-CAB
Colour wire on
A50-LML6-CON-CAB entry cable
To.
or
Connect to
on PWD60-35-70
White 1
White 2
Thermistor
Thermistor
Wire 5
Wire 6
PHOTOMETRIC DATA
Wire 2 350mA
TBD
Red
Driver +
Wires 1 & 2 700mA
IES 32 files available, consult factory
Black
Driver -
Ground
Wire 3
Green
Green / Yellow Stripe
Dialight reserves the right to make changes at any time in order to supply the best product possible.
The most current version of this document will always be available at:
www.dialight.com/Assets\Brochures_And_Catalogs\Illumination\MDEXLUMPWM.pdf
MDEXLUMPWM_B
2
www.dialight.com