5秒后页面跳转
LM611MN PDF预览

LM611MN

更新时间: 2024-11-23 22:31:11
品牌 Logo 应用领域
美国国家半导体 - NSC 运算放大器
页数 文件大小 规格书
17页 737K
描述
Operational Amplifier and Adjustable Reference

LM611MN 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
零件包装代码:DIP包装说明:DIP, DIP8,.3
针数:8Reach Compliance Code:unknown
ECCN代码:EAR99HTS代码:8542.33.00.01
风险等级:5.7放大器类型:OPERATIONAL AMPLIFIER
架构:VOLTAGE-FEEDBACK最大平均偏置电流 (IIB):0.04 µA
25C 时的最大偏置电流 (IIB):0.035 µA标称共模抑制比:90 dB
频率补偿:YES最大输入失调电压:7000 µV
JESD-30 代码:R-PDIP-T8JESD-609代码:e0
长度:9.817 mm低-失调:NO
功能数量:1端子数量:8
最高工作温度:125 °C最低工作温度:-55 °C
封装主体材料:PLASTIC/EPOXY封装代码:DIP
封装等效代码:DIP8,.3封装形状:RECTANGULAR
封装形式:IN-LINE峰值回流温度(摄氏度):NOT SPECIFIED
电源:5 V认证状态:Not Qualified
座面最大高度:5.08 mm最小摆率:0.45 V/us
标称压摆率:0.65 V/us子类别:Operational Amplifier
最大压摆率:0.37 mA供电电压上限:32 V
标称供电电压 (Vsup):5 V表面贴装:NO
技术:BIPOLAR温度等级:MILITARY
端子面层:Tin/Lead (Sn/Pb)端子形式:THROUGH-HOLE
端子节距:2.54 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED标称均一增益带宽:500 kHz
最小电压增益:40000宽度:7.62 mm
Base Number Matches:1

LM611MN 数据手册

 浏览型号LM611MN的Datasheet PDF文件第2页浏览型号LM611MN的Datasheet PDF文件第3页浏览型号LM611MN的Datasheet PDF文件第4页浏览型号LM611MN的Datasheet PDF文件第5页浏览型号LM611MN的Datasheet PDF文件第6页浏览型号LM611MN的Datasheet PDF文件第7页 
May 1998  
LM611  
Operational Amplifier and Adjustable Reference  
General Description  
Features  
The LM611 consists of a single-supply op-amp and a pro-  
grammable voltage reference in one space saving 8-pin  
package. The op-amp out-performs most single-supply  
op-amps by providing higher speed and bandwidth along  
with low supply current. This device was specifically de-  
signed to lower cost and board space requirements in trans-  
ducer, test, measurement and data acquisition systems.  
OP AMP  
n Low operating current: 300 µA (op amp)  
n Wide supply voltage range: 4V to 36V  
n Wide common-mode range: Vto (V+−1.8V)  
n Wide differential input voltage:  
n Available in low cost 8-pin DIP  
±
36V  
n Available in plastic package rated for Military  
Combining a stable voltage reference with a wide output  
swing op-amp makes the LM611 ideal for single supply  
transducers, signal conditioning and bridge driving where  
large common-mode signals are common. The voltage refer-  
ence consists of a reliable band-gap design that maintains  
low dynamic output impedance (1typical), excellent initial  
tolerance (0.6%), and the ability to be programmed from  
1.2V to 6.3V via two external resistors. The voltage refer-  
ence is very stable even when driving large capacitive loads,  
as are commonly encountered in CMOS data acquisition  
systems.  
Temperature Range Operation  
REFERENCE  
n Adjustable output voltage: 1.2V to 6.3V  
n Tight initial tolerance available:  
n Wide operating current range: 17 µA to 20 mA  
n Reference floats above ground  
±
0.6%  
n Tolerant of load capacitance  
Applications  
n Transducer bridge driver  
n Process and Mass Flow Control systems  
n Power supply voltage monitor  
n Buffered voltage references for A/D’s  
As a member of National’s Super-Block family, the LM611  
is a space-saving monolithic alternative to a multi-chip solu-  
tion, offering a high level of integration without sacrificing  
performance.  
Connection Diagrams  
DS009221-1  
DS009221-2  
Super-Block is a trademark of National Semiconductor Corporation.  
© 1999 National Semiconductor Corporation  
DS009221  
www.national.com  

与LM611MN相关器件

型号 品牌 获取价格 描述 数据表
LM612 NSC

获取价格

Dual-Channel Comparator and Reference
LM6121 NSC

获取价格

High Speed Buffer
LM6121_04 NSC

获取价格

High Speed Buffer
LM6121H/883 NSC

获取价格

High Speed Buffer
LM6121J/883 NSC

获取价格

High Speed Buffer
LM6125 NSC

获取价格

High Speed Buffer
LM6125H NSC

获取价格

High Speed Buffer
LM6125H/883 NSC

获取价格

High Speed Buffer
LM6125H/883B ETC

获取价格

Analog Buffer/Voltage Follower
LM6125MD8 TI

获取价格

BUFFER AMPLIFIER, UUC, DIE