Symbol
Current Limit
VCL
Parameter
Threshold voltage
Conditions
VIN-SENSE voltage
Min.
48.5
Typ. Max. Units
55
45
61.5
mV
µs
tCL
Response time
VIN-SENSE stepped from 0 mV to
80 mV
ISENSE
SENSE input current
Enabled, SENSE = OUT
Disabled, OUT = 0V
23
60
µA
Circuit Breaker
VCB
tCB
Threshold voltage
Response time
VIN - SENSE
80
105
130
1.2
mV
µs
VIN - SENSE stepped from 0 mV to
150 mV, time to GATE low, no load
0.44
Timer (TIMER pin)
VTMRH
Upper threshold
Lower threshold
3.76
4
4.16
V
V
VTMRL
Restart cycles (LM5069-2)
1.187
1.25 1.313
End of 8th cycle (LM5069-2)
Re-enable Threshold (LM5069-1)
0.3
0.3
V
V
ITIMER
Insertion time current
3
5.5
1.5
85
8
µA
mA
µA
µA
%
Sink current, end of insertion time
Fault detection current
Fault sink current
TIMER pin = 2V
1.0
51
2.0
120
3.75
1.25
2.5
0.5
12
DCFAULT
tFAULT
Fault Restart Duty Cycle
Fault to GATE low delay
LM5069-2 only
TIMER pin reaches 4.0V
µs
Power Good (PGD pin)
PGDTH
Threshold measured at SENSE-OUT
Decreasing
0.67
0.95
1.25
1.25
1.85
1.55
V
Increasing, relative to decreasing
threshold
PGDVOL
PGDIOH
Output low voltage
Off leakage current
ISINK = 2 mA
VPGD = 80V
60
150
5
mV
µA
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but do not guarantee specific performance limits. For guaranteed specifications and conditions see the Electrical Characteristics.
Note 2: The human body model is a 100 pF capacitor discharged through a 1.5 kΩ resistor into each pin.
Note 3: OUT bias current (disabled) due to leakage current through an internal 1.0 MΩ resistance from SENSE to VOUT.
Note 4: For detailed information on soldering plastic MSOP packages refer to the Packaging Databook available from National Semiconductor Corporation.
Note 5: The GATE pin voltage is typically 12V above VIN when the LM5069 is enabled. Therefore the Absolute Maximum Ratings for VIN (100V) applies only
when the LM5069 is disabled, or for a momentary surge to that voltage since the Absolute Maximum Rating for the GATE pin is also 100V.
www.national.com
4