LM401102-Q-x-301
PIN Diode Limiter
400 - 1000 MHz
Rev. V1
Handling Procedures
Thermal Grounding Caution
Please observe the following precautions to avoid
damage:
Product engineering dictates that the LM family of
high power limiters require proper heat sinking for
high power applications >40 dBm (10 W). MACOM
recommends using the part number PNMN13881
heat sink block which was developed for LM family.
Static and Moisture Sensitivity
These electronic devices are sensitive to
electrostatic discharge (ESD) and can be damaged
by static electricity. Proper ESD control techniques
should be used when handling these Class 0 (HBM)
devices.
Assembly Instructions
The LM401102-Q-x-301 limiters are capable of
being placed onto circuit boards with pick and place
manufacturing equipment from tube or tape & reel
dispensing. The devices are attached to the circuit
board using conventional solder re-flow or wave
soldering procedures with RoHS type or Sn 60 /
Pb 40 type solders per Table I & Graph I Time-
Temperature recommended profile.
The moisture sensitivity level rating for this device is
MSL 1.
Environmental Capabilities
This limiter is capable of meeting the environmental
requirements of MIL-STD-750 and MIL-STD-202.
RF Circuit Solder Footprint, case style 301 (CS301)
Recommended RF circuit is Rogers R04350B, 10 mils thick.
The hatched metal area on circuit side of device is RF, DC and thermal grounded. Vias should be solid copper fill and gold
plated for optimum heat transfer from backside of switch module through circuit vias to metal thermal ground.
4
MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
DC-0015214