LAN9512/LAN9512i
USB 2.0 Hub and 10/100
Ethernet Controller
Datasheet
PRODUCT FEATURES
High-Performance 10/100 Ethernet Controller
Highlights
—
—
—
—
—
—
—
—
—
—
Fully compliant with IEEE802.3/802.3u
Integrated Ethernet MAC and PHY
10BASE-T and 100BASE-TX support
Full- and half-duplex support with flow control
Preamble generation and removal
Automatic 32-bit CRC generation and checking
Automatic payload padding and pad removal
Loop-back modes
Two downstream ports, one upstream port
—
Two integrated downstream USB 2.0 PHYs
—
One integrated upstream USB 2.0 PHY
Integrated 10/100 Ethernet MAC with full-duplex
support
Integrated 10/100 Ethernet PHY with HP Auto-MDIX
Implements Reduced Power Operating Modes
Minimized BOM Cost
TCP/UDP checksum offload support
Flexible address filtering modes
–
–
–
–
–
–
One 48-bit perfect address
64 hash-filtered multicast addresses
Pass all multicast
Promiscuous mode
Inverse filtering
—
Single 25 MHz crystal (Eliminates cost of separate
crystals for USB and Ethernet)
—
Built-in Power-On-Reset (POR) circuit (Eliminates
requirement for external passive or active reset)
Pass all incoming with status report
Target Applications
—
—
Wakeup packet support
Integrated Ethernet PHY
Desktop PCs
–
–
–
Auto-negotiation, HP Auto-MDIX
Automatic polarity detection and correction
Energy Detect
Notebook PCs
Printers
Game Consoles
Embedded Systems
Docking Stations
Power and I/Os
—
—
—
—
—
Three PHY LEDs
Eight GPIOs
Supports bus-powered and self-powered operation
Internal 1.8v core supply regulator
External 3.3v I/O supply
Key Features
USB Hub
Miscellaneous features
—
Fully compliant with Universal Serial Bus Specification
—
—
—
Optional EEPROM
Optional 24MHz reference clock output for partner hub
IEEE 1149.1 (JTAG) Boundary Scan
Revision 2.0
—
HS (480 Mbps), FS (12 Mbps), and LS (1.5 Mbps)
compatible
Software
—
—
—
—
—
Two downstream ports, one upstream port
Port mapping and disable support
—
—
—
—
—
Windows 2000/XP/Vista Driver
Linux Driver
Win CE Driver
MAC OS Driver
EEPROM Utility
Port Swap: Programmable USB diff-pair pin location
PHY Boost: Programmable USB signal drive strength
Select presence of a permanently hardwired USB
peripheral device on a port by port basis
Advanced power saving features
Packaging
—
—
—
64-pin QFN, lead-free RoHS compliant
Downstream PHY goes into low power mode when port
power to the port is disabled
Environmental
—
—
—
—
—
Commercial Temperature Range (0°C to +70°C)
—
Full Power Management with individual or ganged
power control of each downstream port.
Integrated USB termination Pull-up/Pull-down resistors
Internal short circuit protection of USB differential signal
pins
Industrial Temperature Range (-40°C to +85°C)
±8kV HBM without External Protection Devices
±8kV contact mode (IEC61000-4-2)
—
—
±15kV air-gap discharge mode (IEC61000-4-2)
SMSC LAN9512/LAN9512i
Revision 1.0 (11-24-09)
DATASHEET