L99MOD50XP
Multi-output driver for automotive applications
Datasheet - production data
Device contains temperature warning and
protection
Open-load detection for all outputs
Over-current protection for all outputs
PWM control of all outputs
Charge pump output for reverse polarity
protection
ST standard serial peripheral interface
(ST-SPI 3.0)
Features
Applications
AEC-Q100 qualified
L99MOD devices are recommended for those
applications that need multiple motors control with
additional loads in high-side configuration, such
Two half bridges for 6 A load
(R
= 150 m
DSon
as bulbs/LEDs or requiring protected supply, like
sensors or cameras.
Two half bridges for 3 A load (R
Two half bridges for 0.75 A load
= 300 m)
DSon
(R
= 1600 m)
DSon
Description
One high-side driver for 6 A load (R
90 m)
=
DSon
The L99MOD50XP is a microcontroller-driven
multifunctional actuator driver for automotive
applications.
Two configurable high-side drivers for up to
1.5A load (R = 500 mor0.4 A load
DSon
(R
= 1800 m)
DSon
Up to five DC motors and five grounded resistive
loads can be driven with six half bridges and five
high-side drivers.
Two high-side drivers for 0.5 A load
(R = 1600 m)
DSon
Programmable soft start function to drive loads
with higher inrush currents as current limitation
value
The integrated SPI controls all operating modes
(forward, reverse, brake and high impedance).
Also all diagnostic information is available via SPI
read.
Very low current consumption in standby mode
(I < 6 μA typ; T 85 °C; I <5 μA typ;
S
j
CC
T 85 °C)
j
Current monitor output for all high-side drivers
Table 1. Device summary
Package
Order codes
Packing
PowerSSO-36
L99MOD50XPTR
Tape and reel
October 2019
DS12615 Rev 4
1/42
This is information on a product in full production.
www.st.com