HIGH CURRENT MOLDED POWER INDUCTORS
L822HW SERIES
10. RELIABILITY AND TEST CONDITION :
ITEM
PERFORMANCE
TEST CONDITION
Electrical Characteristics Test
HP4284A, CH11025, CH3302, CH1320, CH1320S
LCR meter.
Inductance
Refer to standard electrical characteristics list
DCR
CH16502, Agilent33420A Micro-Ohm Meter.
Heat Rated Current (Irms)
Irms(A) will cause the coil temperature rise
approximately ǻT=40°C without core loss
1. Applied the allowed DC current
2. Temperature measured by digital surface thermometer
Saturation Current (Isat)
Isat(A) will cause Lo to drop approximately 20% typical
Mechanical Performance Test
Solderability Test
More than 90% of the terminal electrode
should be covered with solder.
Preheat : 150°C, 60sec.
Solder : Sn99.95-Cu0.05
Solder Temperature : 230±5°C
Flux for lead free : rosin
Dip Time : 4±1sec.
Preheating
Dipping
Natural
cooling
230°C
150°C
60
4±1
seconds
seconds
Solder Heat Resistance
1. Appearance : No significant abnormally
2. Inductance changed : Within ±20%
Preheat : 150°C, 60sec.
Solder : Sn99.95-Cu0.05
Solder Temperature : 260±5°C
Flux for lead free : rosin
Dip Time : 10±0.5sec.
Preheating
Dipping
Natural
cooling
260°C
150°C
60
10±0.5
seconds
seconds
Reliability Test
High Temperature
Life Test
Temperature : 125±5°C
Time : 500±12 hours
Measure at room temperature after placing for 2 to 3 hrs.
Temperature : -55±5°C
Time : 500±12 hours
Measure at room temperature after placing for 2 to 3 hrs.
Low Temperature
Life Test
1. Appearance : No damage
2. Inductance : Within ±20% of initial value.
No disconnection or short circuit.
Thermal Shock
Conditions of 1 cycle.
Step
Temperature (°C)
-55±3
Times (min.)
30±3
1
2
3
4
Room Temperature
+125±3
Within 3
30±3
Room Temperature
Within 3
Total : 5 cycles
Measure at room temperature after placing for 2 to 3 hrs.
Humidity Resistance
1. Appearance : No damage
Temperature : 40±5°C
Humidity : 90% to 95%
2. Inductance : Within ±20% of initial value.
No disconnection or short circuit.
Applied Current : Rated Curent
Time : 500±12 hours
Measure at room temperature after placing for 2 to 3 hrs.
NOTE : Specifications subject to change without notice. Please check our website for latest information.
15.01.2008
SUPERWORLD ELECTRONICS (S) PTE LTD
PG. 6