5秒后页面跳转
ISL35111 PDF预览

ISL35111

更新时间: 2024-02-17 12:47:25
品牌 Logo 应用领域
英特矽尔 - INTERSIL 驱动
页数 文件大小 规格书
8页 526K
描述
11.1Gb/s Driver

ISL35111 技术参数

生命周期:Unknown零件包装代码:QFN
包装说明:HVQCCN,针数:16
Reach Compliance Code:compliantHTS代码:8542.39.00.01
Factory Lead Time:9 weeks风险等级:5.6
JESD-30 代码:S-PQCC-N16JESD-609代码:e3
长度:3 mm湿度敏感等级:1
功能数量:1端子数量:16
最高工作温度:85 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装形状:SQUARE封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE
峰值回流温度(摄氏度):260认证状态:Not Qualified
座面最大高度:1 mm标称供电电压:1.2 V
表面贴装:YES电信集成电路类型:TELECOM CIRCUIT
温度等级:OTHER端子面层:Matte Tin (Sn) - annealed
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:3 mmBase Number Matches:1

ISL35111 数据手册

 浏览型号ISL35111的Datasheet PDF文件第2页浏览型号ISL35111的Datasheet PDF文件第3页浏览型号ISL35111的Datasheet PDF文件第4页浏览型号ISL35111的Datasheet PDF文件第5页浏览型号ISL35111的Datasheet PDF文件第6页浏览型号ISL35111的Datasheet PDF文件第7页 
11.1Gb/s Driver  
ISL35111  
Features  
• Supports data rates up to 11.1Gbps  
• Low power (85mW typical)  
• Low latency (<500ps)  
The ISL35111 is a de-emphasis driver with extended  
functionality for advanced protocols operating with line  
rates up to 11.1Gbps such as 10G Ethernet. The  
ISL35111 is a high-speed driver/limiting amplifier with  
built-in de-emphasis to drive twin-axial copper cables  
and compensate for the frequency dependent  
• Adjustable output de-emphasis  
• Single channel driver in a 3mmx3mm QFN package  
for straight route-through architecture and simplified  
routing  
attenuation of PCB traces such as the SFI channel in the  
10G SFP+ specification (SFF-8431).  
• Supports 64b/66b encoded data – long run lengths  
• Line silence preservation  
Used in conjunction with Intersil’s ISL36111 receive-side  
equalizer, ISL35111 enables active copper cable  
assemblies that support 10G serial data transmission  
over >15m of twin-axial copper cables.  
• 1.2V supply voltage  
• TX_Disable and TX_LOS  
Operating on a single 1.2V power supply, the ISL35111  
enables channel throughputs of 10Gbps to 11.1Gbps  
while supporting lower data rates including 8.5, 6.25, 5,  
4.25, 3.125, and 2.5Gb/s. The QL111VTx uses current  
mode logic (CML) input/output and is packaged in a  
3mmx3mm 16 lead QFN.  
Applications  
• Active copper cable modules (SFP+, QSFP, CXP, etc)  
• Optical transceiver modules (SFP+, QSFP, CXP, etc)  
• 10G Ethernet  
• 40G/100G Ethernet  
• Fibre Channel  
• High-speed active cable assemblies  
• High-speed printed circuit board (PCB) traces  
Benefits  
• Thinner gauge cable  
• Extends cable reach greater than 3x  
• Improved BER  
Typical Application Diagram  
1.2V  
1.2V  
LOS  
Vdd  
CP-ACP-B  
Vdd  
DE-A DE-B  
LOS  
0.1mF  
0.1mF  
0.1mF  
0.1mF  
0.1mF  
0.1mF  
IN [P]  
OUT [P]  
IN [P]  
OUT [P]  
ISL36111  
OUT [N]  
ISL35111  
IN [N]  
IN [N]  
OUT [N]  
GND  
DT  
TDSBL  
DT  
GND  
FIGURE 1. TYPICAL CABLE APPLICATION DIAGRAM  
November 19, 2009  
FN6975.0  
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.  
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.  
Copyright Intersil Americas Inc. 2009. All Rights Reserved  
1
All other trademarks mentioned are the property of their respective owners.  

与ISL35111相关器件

型号 品牌 描述 获取价格 数据表
ISL35111DRZ-T7 INTERSIL 11.1Gb/s Driver

获取价格

ISL35111DRZ-TS INTERSIL 11.1Gb/s Driver

获取价格

ISL35411 INTERSIL Quad Driver

获取价格

ISL35411DRZ-T7 INTERSIL Quad Driver

获取价格

ISL35411DRZ-TS INTERSIL Quad Driver

获取价格

ISL35822 INTERSIL Octal 2.488Gbps to 3.187Gbps/ Lane Retimer

获取价格