HDC3020-Q1
SNAS817 – JUNE 2021
HDC3020-Q1 Automotive High-Accuracy, Low-Power, Digital Humidity and
Temperature Sensor With Ultra-Low Drift
1 Features
3 Description
•
AEC-Q100 qualified for automotive applications
– Temperature Grade 1: -40°C to 125°C
– Device HBM ESD Classification Level 2
– Device CDM ESD Classification Level C4
Relative humidity (RH) sensor:
– Operating range: 0% to 100%
– Accuracy: ±1.5% typical
– Drift Correction: reduces offset to return device
to within accuracy specification
The HDC3020-Q1 is an integrated capacitive based
relative humidity (RH) and temperature sensor, which
provides high accuracy measurements over a wide
supply range (1.62 V – 5.5 V), along with ultra-low
power consumption in a compact 2.5-mm × 2.5-mm
package. Both the temperature and humidity sensors
are 100% tested and trimmed on a production setup
that is NIST traceable and verified with equipment that
is calibrated to ISO/IEC 17025 standards.
•
– Long-term drift: 0.21%RH/yr
– Condensation protection with integrated heater
Temperature sensor:
– Operating range: -40°C to 125°C
– Accuracy: ±0.1°C typical
NIST traceability: Relative humidity & temperature
Low power: average current 0.7 µA
I2C interface compatibility up to 1-Mhz speeds
– Four selectable I2C addresses
– Command/data protection through CRC
checksum
Supply voltage: 1.62 V to 5.50 V
Available auto measurement mode
Programmable interrupts
Drift Correction reduces RH sensor offset due to
aging, exposure to extreme operating conditions, and
contaminants to return device to within accuracy
specifications. For battery IoT applications, auto
measurement mode and ALERT feature enable low
system power by maximizing MCU sleep time. There
are four different I2C addresses that support speeds
up to 1 MHz. A heating element is available to
dissipate condensation and moisture.
•
•
•
•
Device Information
PART NUMBER
PACKAGE(1)
BODY SIZE (NOM)
•
•
•
•
HDC3020-Q1
WSON (8)
2.50 mm × 2.50 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Programmable measurement calibration
2 Applications
•
•
•
•
•
•
Automotive HVAC control module
Automotive HVAC sensor - air quality
Automotive Particulate Matter PM2.5
Battery Management Systems
On Board Charging
Automotive Camera
3.30 V
HDC3
VDD
VDD
SCL
SDA
I2C
Controller
Calibration
ADC
ALERT
ADDR
ADDR1
RH Sensor
T Sensor
Linearization
I2C
GPIO
µC
Typical RH Accuracy vs. RH Setpoint (TA = 25°C)
RESET
GND
GND
Typical Application
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. ADVANCE INFORMATION for preproduction products; subject to change
without notice.