FULL SIZE D.I.L.
M package
M2001 thru M2007
M2021 thru M2023
M2031 thru M2033
VOLTAGE CONTROLLED
CRYSTAL OSCILLATORS
HCMOS 5V
Thru-Hole / Gull Wing,
0º to 70ºC
HALF SIZE D.I.L.
H package
H2001 thru H2007
H2021 thru H2023
H2031 thru H2033
1 MHz to 175 MHz
DESCRIPTIONS
Center Frequency is Between Two Voltages
Guaranteed
Capture
Range
(ppm)
Control
Center
Frequency
Stability
(ppm)
M2001, H2001
±175 ppm, min. deviation
Control
Voltage
(Volts)
Frequency
Deviation
(ppm)
Voltage
at Center
Frequency
when using 0.3 to 10V control-voltage
MODEL
M2002, H2002
M2003, H2003
M2004, H2004
M2005, H2005
±75 ppm, min. deviation
when using 0.3 to 4.0V control-voltage
2001
2002
2003
2004
2005
2006
2007
0.3 to 10.0
0.3 to 4.0
0.3 to 10.0
0.3 to 4.0
1.0 to 4.0
0 to 5.0
± 175 min
± 75 min
± 175
± 75
2.5 to 5.0
1.3 to 2.3
2.5 to 5.0
1.3 to 2.3
1.8 to 3.0
—
±175 ppm to ±300 ppm deviation when using
0.3 to 10V control-voltage
± 175 to 300
± 125 min
± 75 to 300
± 150 min
± 125 to 250
± 175
± 125
± 75
± 30, typ
±125 ppm min. deviation
± 50, max
when using 0.3 to 4.0V control-voltage
± 150
± 125
±75 ppm to ±300 ppm deviation when using
1.0 to 4.0V control-voltage, for use where the
control voltage is 1 volt off both rails
0.5 to 4.5
1.8 to 3
M2006, H2006
M2007, H2007
M2021, H2021
M2022, H2022
M2023, H2023
M2031, H2031
M2032, H2032
M2033, H2033
±150 ppm, min. deviation when using
0 to 5.0V rail-to-rail control-voltage
Center Frequency is at 2.5V with ±50 ppm stability
±125 ppm to ±250 ppm deviation when using
0.5 to 4.5V control-voltage
Guaranteed
Capture
Range
Control
Voltage
at Center
Frequency
Center
Frequency
Stability
(ppm)
Control
Voltage
(Volts)
Frequency
Deviation
(ppm)
MODEL
±75 ppm capture when using using 0.5 to 4.5V
(ppm)
control-voltage and 2.5V center with ±50 ppm stability
2021
2022
2023
0.5 to 4.5
0.5 to 4.5
0.5 to 4.5
± 75 to 150
± 100 to 200
± 150 to 300
± 75
2.5
2.5
2.5
±100 ppm capture when using using 0.5 to 4.5V
± 30, typ
± 100
± 150
control-voltage and 2.5V center with ±50 ppm stability
± 50, max
±150 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±50 ppm stability
±75 ppm capture when using using 0.5 to 4.5V
Center Frequency is at 2.5V with ±25 ppm stability
control-voltage and 2.5V center with ±25 ppm stability
Guaranteed
Capture
Range
Control
Voltage
at Center
Frequency
Center
Frequency
Stability
(ppm)
±100 ppm capture when using using 0.5 to 4.5V
Control
Voltage
(Volts)
Frequency
Deviation
(ppm)
control-voltage and 2.5V center with ±25 ppm stability
MODEL
±150 ppm capture when using using 0.5 to 4.5V
(ppm)
control-voltage and 2.5V center with ±25 ppm stability
2031
2032
2033
0.5 to 4.5
0.5 to 4.5
0.5 to 4.5
± 75 to 150
± 100 to 200
± 150 to 300
± 75
2.5
2.5
2.5
± 20, typ
± 100
± 150
± 25, max
FREQUENCY STABILITY
Frequency stability vs. Temperature (0 to 70°C) is typically better than
±20 ppm. Since the deviation of each oscillator is tested and guaranteed
over the whole operating temperature range, it is not necessary to make
additional capture allowance. All oscillators will capture frequencies with
the full minimum values of the deviation under all conditions.
PIN 1.
CONTROL VOLTAGE
FET PROBE
V
QUALITY
DD
Y-OUTPUT
350 MHz
SCOPE
+5V
Each VCXO is computer-tested at three temperatures to guarantee
full compliance to the specification.
MA
1
14
(8)
Power
Supply
(1)
LOAD
COUNTER
7
8
GND
(4)
(5)
Half Size connections shown in (
)
To adapt Fet probe to receptacle
use Tektronix Part #103-0164-00
To connect output to scope use
use Tektronix Part #131-0258-00 (receptacle)
ALL OSCILLATORS HAVE INTERNAL BYPASS CAPACITORS
TEST CIRCUIT
ELECTRONICS
10 Commerce Dr
• New Rochelle NY 10801
+
International Sales: 1.914-712-2200 • USA Sales: +1.800.331.1236 • Fax: 914.712.2290 • www.mfelectronics.com • email:sales@mfelectronics.com
2 of 4