Power Management
A A
MICROELECTRONICS
GM2526
DUAL USB POWER SWITCH
Power Management
Features
Description
Compliant to USB Specifications
Two Independent Switches
GM2526 is a dual high-side integrated power switch with in-
dependent enable and flag functions, designed for self-
powered and bus-powered Universal Serial Bus (USB) ap-
plications. GM2526 requires few external components.
Input from 3V to 5.5V
Min. Continuous Load Current 500mA per port
Max. ON-Resistance 140mW
Max. Short Circuit Current Limit 1.25A
Individual Open-Drain Fault Flag Pins
ON-State Supply Current 110µA (typ.)
OFF-State Supply Current 0.75µA (typ.)
Thermal Shutdown
Each of the two switch channels supply up to 500mA as
required by USB downstream devices. Each switch’s low
on-resistance meets USB voltage drop requirements. Fault
current is 750mA (typical). A flag output indicates fault
conditions to the local USB controller. The soft-start feature
prevents the transient voltage drop on the upstream port
that can occur when the switch is enabled in bus-powered
applications. Thermal shutdown protection prevents switch
failure from high-current loads. Undervoltage lockout
(UVLO) hold GM2526 off unless there is a correct input
voltage. GM2526 has 3.3V and 5V logic-compatible Enable
inputs.
Undervoltage Lockout (UVLO) Typically 2.4V
1ms Turn-ON (soft-start) and Fast Turn-OFF
Active-High or Active-Low Enable Versions
Application
USB Power Management
USB Host- and Self-Powered Hubs
USB Bus-Powered Hubs
GM2526 is available in Active-High and Active-Low
versions, and comes in 8-pin DIP and SOIC packages.
Hot Plug-In Power Supplies
Battery-Charger Circuits
CONNECTION DIAGRAM
OUTA
8
ENA/ ENA 1
LOGIC,
CHARGE
PUMP
2
FLGA
IN
7
3
FLGB
LOGIC,
CHARGE
PUMP
4
ENB/ ENB
5
OUTB
6
GND
GM2526 H/ L
www.gammamicro.com
1
PRELIMINARY