FT4233HP Datasheet
Version 1.1
Document No.: FT_001473 Clearance No.: FTDI#555
Future Technology
Devices International Ltd
FT4233HP / FT4232HP
(High Speed USB Bridge with
Type-C/PD3.0 Controller)
Optional traffic TX/RX indicators can be added
with LEDs and an external 74HC595 shift
register.
The FT4233HP/FT4232HP is a Hi-Speed USB device
with a Type-C/PD3.0 controller that fully supports
the latest USB Type-C and Power Delivery (PD)
standards enabling support for power negotiation
Adjustable receive buffer timeout.
Support for USB suspend and resume conditions
via PWREN#, SUSPEND# and RI# pins.
FTDI FT232R/FT-X style, asynchronous serial
UART interface option with full hardware
handshaking and modem interface signals.
Fully assisted hardware or X-On / X-Off software
handshaking.
with the ability to sink or source current to a USB
host device. The USB bridge function delivers 4
independent channels compatible with the existing
FT4232H – Quad Hi-speed USB to multipurpose
UART/MPSSE solution.
The FT4233HP/FT4232HP has the following advanced
UART Interface supports 7/8 bit data, 1/2 stop
bits, and Odd/Even/Mark/Space/No Parity.
Enable control for RS485 serial applications using
TXDEN pin through external EEPROM.
Operational configuration mode and USB
Description strings configurable in external
EEPROM over the USB interface.
Low operating and USB suspend current.
Configurable I/O drive strength (4, 8, 12 or
16mA) and slew rate.
features:
Supports the PD specification Rev 3.0.
Port 1 mode configuration for Sink or Dual-role.
Port 2 works as Sink, supporting charge through
to Port 1(FT4233HPQ and FT4233HPL only).
Supports 5V3A, 9V3A, 12V3A, 15V3A and 20V3A
PDOs as sink or source.
Type-C/PD Physical Layer Protocol.
PD policy engine using 32-bit RISC controller
with 8kB data RAM and 48kB code ROM.
USB Bulk data transfer mode (512 byte packets
in High Speed mode).
PD
EEPROM.
mode
configuration
through
external
Dedicated Windows/Linux DLLs available for USB
to SPI, and USB to I2C applications.
Options to use external MCU controlling PD
policy through I2C interface.
USB to quad serial ports with a variety of
configurations.
Entire USB protocol handled on the chip. No USB
specific firmware programming required.
USB 2.0 High Speed (480Mbits/Second) and Full
Speed (12Mbits/Second) compatible.
Two Multi-Protocol Synchronous Serial Engine
(MPSSE) on channel A and channel B, to simplify
synchronous serial protocol (USB to JTAG, I2C,
SPI or bit-bang) design.
+3.3V single supply operating voltage range.
+3.3V I/O interfacing.
Highly integrated design includes +1.2V LDO
regulator for VCORE, integrated POR function
and on chip clock multiplier PLL (12MHz –
480MHz).
Extended -40°C to 85°C industrial operating
temperature range.
Available in Pb-free QFN-76/QFN-68/LQFP-80
package (RoHS compliant).
Independent Baud rate generators.
RS232/RS422/RS485 UART Transfer Data Rate
up to 12Mbaud. (RS232 Data Rate limited by
external level shifter).
FTDI’s royalty-free Virtual Com Port (VCP) and
Direct (D2XX) drivers eliminate the requirement
for USB driver development in most cases.
Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in
any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied
on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology Devices
International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your statutory rights
are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in which the failure of
the product might reasonably be expected to result in personal injury. This document provides preliminary information that may be subject
to change without notice. No freedom to use patents or other intellectual property rights is implied by the publication of this document.
Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow G41 1HH United Kingdom.
Scotland Registered Company Number: SC136640
Copyright © Future Technology Devices International Limited
1
国产x86处理器里程碑！兆芯6000台医疗电脑中标某总医院
稚晖君团队开源GO-1模型：ViLLA架构如何重塑具身智能未来？
安森美收购奥拉半导体Vcore技术 抢占AI数据中心电源管理制高点
PCIe 8.0规范草案获里程碑进展：256GT/s速率开启1TB/s带宽时代
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
