Fusible Nickel
Film Resistors
Welwyn Components
FN Series
• Predictable fusing characteristics
Constant current fusing
•
Flameproof
•
Electrical Data
FN4
Power rating at 70°C
Resistance range
watts
ohms
0.4
0R1 to 20R
TCR
ppm/°C
%
See Figure 1
5, 10, 20
E24 preferred
215
Resistance tolerance*
Standard values
Thermal impedance
Ambient temperature range
°C/watt
°C
-55 to 155
* Below 1R, 10 and 20% only.
Physical Data
Dimensions (mm) & Weight (g)
PCB
Min.
bend
radius
mounting
centres
Wt.
d
Type
L Max
6.2
D Max
2.5
f min
21.0
d nom
0.6
nom
D
L
f
FN4
10.2
0.6
0.3
Construction
Marking
The nickel film is deposited on a high purity ceramic rod. End
caps are force fitted and termination wires welded to the
caps. The resistive film is adjusted to the required value by a
helical cut; finally the flame retardant lacquer protection is
applied to the resistor body and the resistor is marked with an
indelible ink.
Resistors are colour coded with five bands. Four of the bands
are used to indicate value and tolerance, with IEC 62 colours
being used. A fifth black band denotes constant current
fusibility.
Solvent Resistance
The body protection and marking are resistant to all normal
Terminations
industrial cleaning solvents suitable for printed circuits.
Material
Solder-coated copper wire.
Flammability
Strength
The terminations meet the requirements of
IEC 68.2.21
The resistors will not burn or emit encandescent particles
under any condition of applied temperature or power
overload.
Solderability The terminations meet the requirements of
IEC 115-1, Clause 4.17.3.2
General Note
Welwyn Components reserves the right to make changes in product specification without notice or liability.
All information is subject to Welwyn’s own data and is considered accurate at time of going to print.
A subsidiary of
TT electronics plc
© Welwyn Components Limited · Bedlington, Northumberland NE22 7AA, UK
Telephone: +44 (0) 1670 822181 · Facsimile: +44 (0) 1670 829465 · Email: info@welwyn-tt.com · Website: www.welwyn-tt.com
Issue B · 03.02
168