Snap-in Bolts for PCB Mounting
Schnappbolzen für Leiterplattenmontage
For PCBs with 2.ꢁ mm (0.09ꢁ”) Thickness (Recommended Diameter of the Assembly Drilling 3.0 mm 0.1 (0.11ꢀ” 0.00ꢁ))
Für Leiterplatten mit 2,4 mm Stärke (empfohlener Durchmesser der Montagebohrungen 3,0 mm 0,1ꢀ
For PCBs with 3.2 mm (0.126”) Thickness (Recommended Diameter of the Assembly Drilling 3.0 mm 0.1 (0.11ꢀ” 0.00ꢁ))
Für Leiterplatten mit 3,2 mm Stärke (empfohlener Durchmesser der Montagebohrungen 3,0 mm 0,1ꢀ
The modification number for the snap-in bolts completes the order number for the connector on which they are mounted.
Platings: Tin plated over nickel, only when using tin-plated shells.
Die Modifikationsnummer des Schnappbolzens ergänzt die Bestellnummer des Steckverbinders, in den der Schnappbolzen eingebaut ist.
Oberflächen: Verzinnt über Nickel, nur in Verbindung mit verzinntem Gehäuse.
For the assembly and positioning of connectors, FCT has modified it’s well
proven snap-in bolts and snap-in rivets.
Für die Montage und Positionierung der Steckverbinder hat FCT electronic
die bewährten Schnappbolzen und Snap-in Nieten modifiziert.
The advantages of this new design are:
Die Vorteile der neuen Geometrie sind:
•
•
•
less snap-in force required for an increased retention strength.
constant development of power when snapping in
less sensitivity to the tolerance of the assembly hole.
•
•
•
geringere Einpresskraft bei hoher Haltekraft
gleichmäßiger Kraftverlauf beim Einpressen
geringere Empfindlichkeit gegenüber Montagelochtoleranzen.
As a result the required press-in force on to the PCB is lessened without
diminishing the retention strength.
Dadurch wird eine weichere Einrastung auf der Leiterplatte ohne
Verringerung der Haltekraft erreicht.
Depending on the snap-in rivet, the press in strength per snap-in rivet, with a
diameter of 3 mm, lies between 20 - 60 N. In contrast a press in strength of
100 N was required with the previous snap-in geometry.
Abhängig vom Snap-in Niet liegen die Einpresskräfte pro Snap-in Niet bei
einem Durchmesser von 3 mm bei 20 - 60 N. Bei der bisherigen Snap-in
Geometrie waren dagegen Einpresskräfte bis 100 N erforderlich.
TECHNISCHE ÄNDERUNGEN VORBEHALTEN – MAßE IN MILLIMETER (INCHES IN KLAMMERN)
6ꢁ
DS 10/2005