EL2257C/EL2357C
125 MHz Single Supply, Clamping Op Amps
DC Electrical Characteristics (Continued)
VS=+5V, GND=0V, TA=25°C, VCM=1.5V, VOUT=1.5V, VCLAMP=+5V, VENABLE=+5V, unless otherwise specified.
Test
Parameter
Description
Test Conditions
VS=+12V, AV=+1, RL=1 kΩ to 0V
VS=+12V, AV=+1, RL=150Ω to 0V
VS=±5V, AV=+1, RL=1 kΩ to 0V
VS=±5V, AV=+1, RL=150Ω to 0V
VS=+3V, AV=+1, RL=150Ω to 0V
VS=+12V, AV=+1, RL=150Ω to 0V
VS=±5V, AV=+1, RL=1 kΩ to 0V
VS=±5V, AV=+1, RL=150Ω to 0V
VS=±5V, AV=+1, RL=10Ω to 0V
VS=±5V, AV=+1, RL=50Ω to 0V
VENABLE=+0.5V
Min
Typ
10.8
10.0
4.0
Max
Level
Units
V
VOP
Positive Output Voltage Swing
V
I
9.6
V
V
I
V
3.4
1.8
3.8
V
1.95
5.5
I
V
VON
Negative Output Voltage Swing
8
I
mV
V
-4.0
-3.7
±100
±60
0
V
I
-3.4
V
[1]
IOUT
Output Current
±75
2.0
I
mA
mA
µA
V
V
I
IOUT,OFF
VIH-EN
VIL-EN
IIH-EN
Output Current, Disabled
20
ENABLE pin Voltage for Power Up
Relative to GND Pin
I
ENABLE pin Voltage for Shut Down
Relative to GND Pin
0.5
410
1
I
V
[2]
ENABLE pin Input Current-High
ENABLE pin Input Current-Low [2]
VS=VCLAMP=+12V, VENABLE=+12V
VS=VCLAMP=+12V, VENABLE=+0.5V
Relative to GND Pin
340
0
I
µA
µA
V
IIL-EN
I
[3]
VOR-CL
VACC-CL
Voltage Clamp Operating Range
CLAMP Accuracy [4]
1.2
VOP
250
I
VIN=+4V, RL=1 kΩ to GND
-250
100
I
mV
VCLAMP=+1.5V and +3.5V
IIH-CL
IIL-CL
CLAMP pin Input Current - High
VS=VCLAMP=+12V
12
25
I
I
µA
µA
CLAMP pin Input Current - Low / Per
Amplifier
VS=+12V, VCLAMP=+1.2V
-30
-15
1. Internal short circuit protection circuitry has been built into the EL2257C/EL2357C. See the Applications section.
2. If the disable feature is not desired, tie the ENABLE pins to the VS pin, or apply a logic high level to the ENABLE pins.
3. The maximum output voltage that can be clamped is limited to the maximum positive output Voltage, or VOP. Applying a Voltage higher than VOP
inactivates the clamp. If the clamp feature is not desired, either tie the CLAMP pin to the VS pin, or simply let the CLAMP pin float.
4. The clamp accuracy is affected by VIN and RL. See the Typical Curves Section and the Clamp Accuracy vs. VIN and RL curve.
3