5秒后页面跳转
DS3102 PDF预览

DS3102

更新时间: 2023-12-06 20:02:19
品牌 Logo 应用领域
TTELEC /
页数 文件大小 规格书
4页 682K
描述
Loop Powered Indicator

DS3102 数据手册

 浏览型号DS3102的Datasheet PDF文件第2页浏览型号DS3102的Datasheet PDF文件第3页浏览型号DS3102的Datasheet PDF文件第4页 
Loop Powered Indicator  
DS3102  
Features:  
Large 20mm LCD display  
Only 1 volt from loop  
Loop powered  
Stainless Steel case 100mm dial  
Sensor / wall / panel mount  
IP65 enclosure  
Descripꢀon:  
The GEN500 is a loop powered indicator which is designed for series connecꢁon into a 4/20mA current loop and  
to display digitally, in engineering units, the process variable represented by the current flow. The GEN500 needs  
only 1 volt from the loop. The GEN500X is a version approved for hazardous area use and requires 1.6 volts from  
the loop. Style Fand G housing will accommodate any suitable in head transmiꢀer.  
INSTALLATION & WIRING  
General Precauꢁons  
a) The indicator should remain in its packaging prior to installaꢁon and stored in a dry environment not subject  
to extremes of temperature.  
b) The indicator should not be installed adjacent to switch gear, electromagneꢁc starters, contactors, thyristor  
power units or motors.  
c) The signal cables connected to the indicator should not run in the same trunking as power cables. Screened  
cables are recommended at all ꢁmes.  
d) The electronic circuit will be affected by moisture and in some cases be damaged beyond repair. Always  
ensure the case is assembled correctly.  
in some cases be damaged beyond repair.  
Always ensure the case is assembled correctly.  
e) On the MD500X the following precauꢁons MUST be observed when used in hazardous areas:  
1) The electrical circuit in the hazardous area must be capable of withstanding an A.C. test voltage of  
500V RMS to earth or frame of the apparatus.  
2) The capacitance and either the inductance or the inductance to resistance (L/R) raꢁo of the hazardous  
area cables must not exceed the parameters specified in the schedule of the appropriate safety barrier  
cerꢁficate and/or systems cerꢁficate.  
3) The installaꢁon must comply with requirement as specified in BS5345 Part 4 1977.  
General Note  
TT Electronics | Roxspur Measurement & Control  
2 Downgate Drive, Sheffield, South Yorkshire, S4 8BT, UK |Ph: +44 (0) 114-244-2521  
TT Electronics reserves the right to make changes in product specificaꢁon without  
noꢁce or liability. All informaꢁon is subject to TT Electronics’ own data and is  
considered accurate at ꢁme of going to print.  
www.ꢀelectronics.com | RoxspurSales@ꢀelectronics.com  
Issue A 07/2018 Page 1  
© TT electronics plc  

与DS3102相关器件

型号 品牌 获取价格 描述 数据表
DS3102_08 MAXIM

获取价格

Stratum 3 Timing Card IC with Synchronous Ethernet Support
DS3102E10SL-3P AMPHENOL

获取价格

MIL Series Connector, 3 Contact(s), Aluminum Alloy, Male, Solder Terminal, Receptacle,
DS3102E10SL-3S AMPHENOL

获取价格

MIL Series Connector, 3 Contact(s), Aluminum Alloy, Female, Solder Terminal, Receptacle,
DS3102E10SL-4S AMPHENOL

获取价格

暂无描述
DS3102E-14S-5P AMPHENOL

获取价格

MIL Series Connector, 5 Contact(s), Aluminum Alloy, Male, Solder Terminal, Receptacle,
DS3102E20-27S AMPHENOL

获取价格

MIL Series Connector, 17 Contact(s), Aluminum Alloy, Female, Solder Terminal, Receptacle,
DS3102GN MAXIM

获取价格

Stratum 3 Timing Card IC with Synchronous Ethernet Support
DS3102GN+ MAXIM

获取价格

Stratum 3 Timing Card IC with Synchronous Ethernet Support
DS3102GN2 MICROSEMI

获取价格

ATM/SONET/SDH IC,
DS3103 TTELEC

获取价格

Infrared Thermometer