����������������������������������������������������������������� ꢀMaxim Integrated Productsꢀ ꢀ 1
19-6164; Rev 0; 12/11
DS2483
Single-Channel 1-Wire Master
with Adjustable Timing and Sleep Mode
General Description
Benefits and Features
2
M
2
2
The DS2483 is an I C-to-1-Wire bridge device that
interfaces directly to standard (100kHz max) or fast
SꢀI CꢀHostꢀInterfaceꢀSupportsꢀ100kHzꢀandꢀ400kHzꢀ
I CꢀCommunicationꢀSpeeds
2
(400kHz max) I C masters to perform protocol con-
version between the I C master and any downstream
SꢀStandardꢀandꢀOverdriveꢀ1-WireꢀCommunicationꢀ
2
Speeds
1-Wire slave devices. Relative to any attached 1-Wire
slave device, the DS2483 is a 1-Wire master. Internal,
user-adjustable timers relieve the system host processor
from generating time-critical 1-Wire waveforms, support-
ing both standard and overdrive 1-Wire communication
speeds. In addition, the 1-Wire bus can be powered
down under software control. The dual-voltage operation
SꢀAdjustableꢀ1-WireꢀTimingꢀforꢀt
,ꢀt
,ꢀt
,ꢀ
RSTL MSP W0L
andꢀt
REC0
Sꢀ1-WireꢀPortꢀCanꢀBeꢀPoweredꢀDownꢀUnderꢀ
SoftwareꢀControl
SꢀSupportsꢀPower-SavingꢀSleepꢀModeꢀ(SLPZꢀPin),ꢀ
Whereꢀtheꢀ1-WireꢀPortꢀisꢀinꢀHighꢀImpedance
2
allows different operating voltages on the I C and 1-Wire
2
SꢀI CꢀOperatingꢀVoltages:ꢀ1.8Vꢀ±±5,ꢀ3.3Vꢀ±105,ꢀandꢀ
side. Strong pullup features support 1-Wire power deliv-
ery to 1-Wire devices such as EEPROMs and sensors.
When not in use, the DS2483 can be put in sleep mode
where power consumption is minimal.
±.0Vꢀ+±/-105
SꢀBuilt-InꢀLevelꢀTranslator:ꢀ1-WireꢀOperatingꢀVoltageꢀ
2
fromꢀ1.8Vꢀ-±5ꢀtoꢀ±.0Vꢀ+±5,ꢀIndependentꢀofꢀI Cꢀ
Voltage
Applications
SꢀBuilt-InꢀESDꢀProtectionꢀLevelꢀofꢀ±8kVꢀHumanꢀ
BodyꢀModelꢀ(HBM)ꢀContactꢀDischargeꢀonꢀIOꢀPin
Printers
Sꢀ-40NCꢀtoꢀ+8±NCꢀOperatingꢀTemperatureꢀRangeꢀ
Sꢀ8-PinꢀTDFNꢀandꢀ6-PinꢀSOT23ꢀPackages
Medical Instruments
Industrial Sensors
Cell Phones
Ordering Information appears at end of data sheet.
Typical Application Circuit
3V
5V
R *
P
V
CC
SDA
SCL
2
(I C PORT)
µC
DS2483
1-Wire BUS
SLPZ
IO
1-Wire
1-Wire
1-Wire
DEVICE #1
DEVICE #2
DEVICE #n
2
*R = I C PULLUP RESISTOR (SEE THE Pullup Resistor R Sizing SECTION FOR R SIZING)
P
P
P
1-Wire is a registered trademark of Maxim Integrated Products, Inc.
For related parts and recommended products to use with this part, refer to: www.maxim-ic.com/DS2483.related
Forꢀpricing,ꢀdelivery,ꢀandꢀorderingꢀinformation,ꢀpleaseꢀcontactꢀMaximꢀDirectꢀatꢀ1-888-629-4642,ꢀ
orꢀvisitꢀMaxim’sꢀwebsiteꢀatꢀwww.maxim-ic.com.