Datasheet > DS1855B-020

DS1855B-020

更新时间： 2022-11-26 01:17:17

品牌	Logo	应用领域
达拉斯 - DALLAS		电位器存储
页数	文件大小	规格书
20页	252K
描述
Dual Nonvolatile Digital Potentiometer and Secure Memory

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

DS1855B-020 数据手册

DS1855

PIN DESCRIPTIONS

Name TSSOP BGA

Description

V_CC

Power Supply Terminal. The DS1855 will support supply

voltages ranging from +2.7V to +5.5V.

GND

SDA

Ground Terminal.

2-Wire serial data interface. The serial data pin is for serial data

transfer to and from the DS1855. The pin is open drain and may

be wire-ORed with other open drain or open collector interfaces.

2-Wire Serial Clock Input. The serial clock input is used to

clock data into the DS1855 on rising edges and clock data out on

falling edges.

SCL

Write Protect Input. If set to logic 0, the data in memory and the

potentiometer wiper setting may be changed. If set to logic 1, both

the memory and the potentiometer wiper settings will be write

protected. The WP pin is pulled high internally.

Address Input. Pins A0, A1, and A2 are used to specify the

address of each DS1855 when used in a multi-dropped

configuration. Up to eight DS1855s may be addressed on a single

2-wire bus.

Address Input.

High terminal of Potentiometer 0. For both potentiometers, it is

not required that the high terminal be connected to a potential

greater than the low terminal. Voltage applied to the high terminal

of each potentiometer cannot exceed V_CCor go below ground.

High terminal of Potentiometer 1.

Low terminal of Potentiometer 0. For both potentiometers, it is

not required that the low terminal be connected to a potential less

than the high terminal. Voltage applied to the low terminal of each

potentiometer cannot exceed V_CCor go below ground.

Low terminal of Potentiometer 1.

Wiper terminal of Pot 0. The wiper position of Potentiometer 0

is determined by the byte at EEPROM memory location F9h.

Voltage applied to the wiper terminal of each potentiometer cannot

exceed the power supply voltage, V_CC, or go below ground.

Wiper terminal of Pot 1. The wiper position of Potentiometer 1

is determined by the byte at EEPROM memory location F8h.

No Connect.

2 of 20

123 4 5 6 7...20

下载PDF

与DS1855B-020相关器件

型号	品牌	描述	获取价格	数据表
DS1855B-050	DALLAS	Dual Nonvolatile Digital Potentiometer and Secure Memory	获取价格
DS1855B-100	DALLAS	Dual Nonvolatile Digital Potentiometer and Secure Memory	获取价格
DS1855B-100+	MAXIM	Digital Potentiometer, 2 Func, 100000ohm, 2-wire Serial Control Interface, 256 Positions,	获取价格
DS1855E-010	DALLAS	Dual Nonvolatile Digital Potentiometer and Secure Memory	获取价格
DS1855E-010/R	DALLAS	Dual Nonvolatile Digital Potentiometer and Secure Memory	获取价格
DS1855E-010/T	DALLAS	Dual Nonvolatile Digital Potentiometer and Secure Memory	获取价格