CY8CMBR2010
■ Ensures portability of the user interface design.
Configuring the CY8CMBR2010
■ Compensates Printed Circuit Board (PCB) variations, Device
process variations, and PCB vendor changes.
The CY8CMBR2010 device features are configured using
external resistors.
General-Purpose Outputs
■ GPOx pin outputs are strong drive[3]
The resistors on the hardware configurable pins are determined
by the device upon power-on.
The Appendix on page 28 gives the matrix of features enabled
using different external resistor configurations.
■ The GPOx is controlled by the corresponding CSx
To know more about the required settings for your design, refer
to the CY8CMBR2010 Design Guide.
■ Active low output – supports sinking configuration for LEDs
(see Figure 3)
■ If CSx is disabled (grounded), then the corresponding GPOx
must be left floating
Device Features
CapSense Buttons
■ A 5-ms pulse is sent after 350 ms (if Noise Immunity level is
“Normal”) / 1000 ms (if Noise Immunity level is “High”) after
power-up on the GPOx if the CSx fails the System Diagnostics
■ Supports up to ten CapSense buttons.
■ Ground the CSx pin to disable CapSense button input.
Figure 3. Example of GPO0 Driven by CS0
■ A 2.2 nF (±10%) capacitor must be connected on the CMOD pin
for proper CapSense operation.
S
e
u
n
tt
s
o
o
n
r
Button
Sensor
Touched
Released
■ For proper CapSense operation, ensure CP of each button is
less than 40 pF.
SmartSense™ Auto-Tuning
CS0
■ Supports auto-tuning of CapSense parameters
■ No manual tuning required; all parameters are automatically
tuned by the device.
GPO0
■ Reduces the design cycle time.
❐ No manual tuning.
Table 2. Advanced Features Supported by CY8CMBR2010
Feature
Benefit
Toggle ON/OFF
Button retains state on touch (ON/OFF)
Flanking Sensor Suppression (FSS)
Noise Immunity
Helps in distinguishing closely spaced buttons
Improves device immunity to external noise (such as RF noise)
Gives an LED effect on button release
LED ON Time
Button Auto Reset
Disables false output trigger, due to conducting object placed close to button
Provides visual effects to design at power-on
Power-on LED Effects
Analog Voltage Support
LED Backlighting
External resistors can be used with GPOs to generate analog voltage output
Common GPO available for LED drive if Analog Voltage Support enabled
Sensitivity Control for CS0 Button and Debounce Useful for special function buttons such as power button
Control for CS0 Button
System Diagnostics
Serial Debug Data
Support for production testing and debugging
Support for production testing and validating design
Low Power Sleep Mode and Deep Sleep Mode Low power consumption
Note
3. When a pin is in strong drive mode, it is pulled up to V when the output is HIGH and pulled down to Ground when the output is LOW.
DD
Document Number: 001-74495 Rev. *A
Page 6 of 31