CY7C1302CV25
PREMILINARY
9-Mbit Burst of Two Pipelined SRAMs
with QDR™ Architecture
Functional Description
Features
• Separate independent Read and Write data ports
— Supports concurrent transactions
• 167-MHz clock for high bandwidth
— 2.5 ns clock-to-Valid access time
• 2-word burst on all accesses
The CY7C1302CV25 is a 2.5V Synchronous Pipelined SRAM
equipped with QDR™ architecture. QDR architecture consists
of two separate ports to access the memory array. The Read
port has dedicated data outputs to support Read operations
and the Write Port has dedicated data inputs to support Write
operations. Access to each port is accomplished through a
common address bus. The Read address is latched on the
• Double Data Rate (DDR) interfaces on both Read and
rising edge of the K clock and the Write address is latched on
the rising edge of K clock. QDR has separate data inputs and
data outputs to completely eliminate the need to “turn-around”
the data bus required with common I/O devices. Accesses to
the CY7C1302CV25 Read and Write ports are completely
independent of one another. All accesses are initiated
synchronously on the rising edge of the positive input clock
(K). In order to maximize data throughput, both Read and
Write ports are equipped with DDR interfaces. Therefore, data
can be transferred into the device on every rising edge of both
input clocks (K and K) and out of the device on every rising
edge of the output clock (C and C, or K and K in a single clock
domain) thereby maximizing performance while simplifying
system design. Each address location is associated with two
18-bit words that burst sequentially into or out of the device.
Write ports (data transferred at 333 MHz) @ 167 MHz
• Two input clocks (K and K) for precise DDR timing
— SRAM uses rising edges only
• Two output clocks (C and C) account for clock skew
and flight time mismatching
• Single multiplexed address input bus latches address
inputs for both Read and Write ports
• Separate Port Selects for depth expansion
• Synchronous internally self-timed writes
• 2.5V core power supply with HSTL Inputs and Outputs
• 13 x 15 x 1.4 mm 1.0-mm pitch fBGA package, 165 ball
(11 x 15 matrix)
Depth expansion is accomplished with a Port Select input for
each port. Each Port Select allows each port to operate
independently.
All synchronous inputs pass through input registers controlled
by the K or K input clocks. All data outputs pass through output
registers controlled by the C or C (or K or K in a single clock
domain) input clocks. Writes are conducted with on-chip
synchronous self-timed write circuitry.
• Variable drive HSTL output buffers
• Expanded HSTL output voltage (1.4V–1.9V)
• JTAG Interface
Configurations
CY7C1302CV25 – 512K x 18
Logic Block Diagram (CY7C1302CV25)
D[17:0]
18
Write
Write
Data Reg
Data Reg
Address
Register
A
(17:0)
Address
Register
A(17:0)
18
18
256Kx18 256Kx18
Memory Memory
Array
Array
K
CLK
Gen.
RPS
Control
Logic
K
C
C
Read Data Reg.
36
18
Vref
18
Reg.
Reg.
Reg.
18
18
Control
Logic
WPS
18
BWS0
Q[17:0]
BWS1
Cypress Semiconductor Corporation
•
3901 North First Street
•
San Jose, CA 95134
•
408-943-2600
Document #: 38-05491 Rev. *A
Revised June 1, 2004