BQ77216
SLUSE36 – AUGUST 2020
www.ti.com
Typical values stated where TA = 25°C and VDD = 58 V, MIN/MAX values stated where TA = –40°C to 85°C and
VDD = 5 V to 75 V (unless otherwise noted).
PARAMETER
TOT_HYS OT Detection Hysteresis
TOT_ACC
TEST CONDITIONS
MIN
TYP
MAX
UNIT
–10
°C
4186
3530
Ω
Ω
OT Detection Accuracy
–5
5
°C
(1)
RNTC
Internal Pull Up Resistor
After TI Factory Trim
19.5
20
20.5
kΩ
OPEN WIRE PROTECTION (OW)
Vn < Vn-1 where n = 2 to 16
V1 - VSS
–200
200
mV
mV
mV
mV
mV
VOW
OW Detection Threshold(1)
VOW_HYS OW Detection Hysteresis
Vn < Vn-1 where n = 1 to 16
TA = 25℃
100
OW Detection Accuracy
VOW_ACC
–12
–25
12
25
OW Detection Accuracy
-40 ℃ ≤ TA ≤ 110℃
SUPPLY AND LEAKAGE CURRENT
ICC
Supply Current
No fault detected.
1
2
µA
µA
Vn - Vn-1 and V1 - VSS = 4V, where n =
2 to 16
–0.2
–0.1
0.2
IIN
Input Current at Vx Pins
Vn - Vn-1 and V1 - VSS = 4V, where n =
2 to 16
0.1
µA
OUTPUT DRIVE, COUT and DOUT, CMOS ACTIVE HIGH VERSIONS ONLY
Vn - Vn-1 or V1 - VSS > VOV, where n = 2
to 16, VDD = 58 V, IOH = 100 µA
measured into COUT, DOUT pin.
6
0
V
V
VDD - VCOUT or VDOUT, Vn - Vn-1 or V1 -
VSS > VOV, where n = 2 to 16, IOH = 10
µA measured into COUT, DOUT pin.
1
1
1.5
1.5
Output Drive Voltage for COUT and
DOUT, Active High
VOUT_AH
VDD - VCOUT or VDOUT, If 15 of 16 cells
are short circuited and only one cell
remains powered and > VOV, VDD = Vx
(cell voltage), IOH = 100 µA,
0
V
Vn - Vn-1 and V1 - VSS < VOV, where n =
2 to 16, VDD = 58 V, IOH = 100 µA
measured into pin
250
100
400
120
4.5
mV
kΩ
ROUT_AH Internal Pull Up Resistor
IOUT_AH_
80
Vn - Vn-1 or V1 - VSS > VOV, where n = 2
to 16, VDD = 58 V, OUT = 0V. Measured
out of COUT, DOUT pin
OUT Source Current (during OV)
mA
H
Vn - Vn-1 and V1 - VSS < VOV, where n =
2 to 16, VDD = 58 V, OUT = VDD.
Measured into COUT, DOUT pin
IOUT_AH_L OUT Sink Current (no OV)
0.3
3
mA
OUTPUT DRIVE, COUT and DOUT, NCH OPEN DRAIN ACTIVE LOW VERSIONS ONLY
Vn - Vn-1 or V1 - VSS > VOV, where n = 2
Output Drive Voltage for COUT and
DOUT, Active Low
VOUT_AL
to 16, VDD = 58 V, IOH = 100 µA
measured into COUT, DOUT pin.
250
400
3
mV
mA
nA
Vn - Vn-1 or V1 - VSS > VOV, where n = 2
to 16, VDD = 58 V, OUT = VDD.
Measured into COUT, DOUT pin.
IOUT_AL_L OUT Source Current (during OV)
IOUT_AL_H OUT Sink Current (no OV)
0.3
Vn - Vn-1 and V1 - VSS < VOV, where n =
2 to 16, VDD = 58 V, OUT = VDD.
Measured out of COUT, DOUT pin.
100
(1) Open wire may not work properly if the cell voltage is below 2.8 V.
Copyright © 2020 Texas Instruments Incorporated
6
Submit Document Feedback
Product Folder Links: BQ77216