Leaded varistors, SNF high operating temperature
SNF AdvanceD-MP, SNF10 series
B722*
Test
Test methods/ conditions
Requirement
|∆V/V (1 mA)| ≤10%
ins ≥100 MΩ
Climatic sequence
The specimen shall be subjected to:
a) dry heat at UCT, 16 h, IEC 60068-2-2,
test Ba
R
b) damp heat, 1st cycle:
55 °C, 93% r. H., 24 h, IEC
60068-2-30, test Db
c) cold, LCT, 2 h, IEC 60068-2-1, test Aa
d) damp heat, additional 5 cycles:
55 °C/25 °C, 93% r. H., 24 h/cycle,
IEC 60068-2-30, test Db.
Then the specimen shall be stored at
room temperature and normal humidity
for 1 to 2 h.
Thereafter, the change of VV shall be
measured. Thereafter, insulation resis-
tance Rins shall be measured at V = 500
V.
Rapid change of
temperature
IEC 60068-2-14, test Na, LCT/UCT,
dwell time 10 min, 1000 cycles
|∆V/V (1 mA)| ≤5%
No visible damage
Damp heat
IEC 60068-2-78, test Cy
|∆V/V (1 mA)| ≤10%
85 °C, 85% r. H., 0.85 * Vv (1 mA), 1000 No visible damage
h
Solderability
IEC 60068-2-20, test Ta,
The inspection shall be
carried out under adequate
light with normal eyesight or
with the assistance of a
magnifier capable of giving a
magnification of 4 to
10 times. The dipped surface
shall be covered with a
smooth and bright solder
coating with no more than
small amounts of scattered
imperfections such as
method 1 with modified conditions for
lead-free solder alloys: 245 °C, 3 s:
After dipping the terminals to a depth of
approximately 3 mm from the body in a
soldering bath of 245 °C for 3 s, the
terminals shall be visually examined.
pinholes or un-wetted or
de-wetted areas. These
imperfections shall not be
concentrated in one area.
Please read Cautions and warnings and
Important notes at the end of this document.
Page 6 of 21