Film Capacitors – Power Factor Correction
Thyristor module
B44066T3050E690
TSM-LC-N690
Putting into operation
After switching on the grid voltage (engaging of branch fuse) the thyristor is ready for operation.
The switch features 2 status-LEDs with following signification:
LED left
Green:
Red constant:
Red flashing:
operation voltage applied, switch in standby
capacitor defect or not available; fuse or thyristor defect
Grid voltage L1/L3 missing or too low (< 350 V)
LED right
Green:
Red flashing:
“Module ON” (trigger)
Overtemperature
Technical data and specifications
Dimensions
157 x 200 x 190 mm (W x H x D) – without connection clamps
Weight
4.8 kg
Operating voltage
Nominal voltage (phase voltage)
380 … 690 V AC
Step output:
Current/phase Electronic fuse “super fast”
(NH00 AC 690 V)
- 690 V
- 525 V
- 480 V
- 440 V
- 400 V
75 kvar
55 kvar
50 kvar
45 kvar
40 kvar
ca. 60 A
ca. 60 A
ca. 60 A
ca. 60 A
ca. 60 A
3x 125 A/690 V
3x 125 A/690 V
3x 125 A/690 V
3x 125 A/690 V
3x 125 A/690 V
Frequency
50/60 Hz
Auxiliary supply
230 V~/10 VA (mandatory needed, module does not work without
external auxiliary supply)
Triggering
10 … 24 V DC (ca. 10 mA) via connection clamp, internally
galvanically de-coupled
Switching time
Re-switching time
Switching capacity
Display
ca. 5 ms
Depending on de-tuning factor and discharge resistor used
Approx. 60 A
Via 2 LED (see above)
Monitoring
Voltage, operation status and temperature
Operating
For re-switching the heat sink must go below +50 °C after a
temperature error (hysteresis)
Power circuit
Power loss
Direct connection via high current plug; connection from the bottom
Pv (in W) = 2.4 I (in A);
appr. 150 W thermal at nominal current
Ambient operating temperature at
nominal load
-10 … +55 °C
CAP FILM P PM PFC
Jan 2015
Please read Cautions and warnings and
Page 3 of 6
Important notes at the end of this document.