Datasheet > B25667B2607A175

B25667B2607A175

更新时间： 2024-02-13 03:38:08

品牌	Logo	应用领域
爱普科斯 - EPCOS		电容器薄膜电容器功率因数校正
页数	文件大小	规格书
8页	121K
描述
Film Capacitors - Power Factor Correction

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

B25667B2607A175 数据手册

Film Capacitors – Power Factor Correction

PhaseCap capacitors

B25667B2607A175

MKK230-I-10-01

Overpressure disconnector

To ensure full functionality of an overpressure disconnector, the following must be observed:

1. The elastic elements must not be hindered, i.e.

- connecting lines must be flexible leads (cables),

- there must be sufficient space (min. 12 mm) for expansion above the connections. This will

enable a longitudinal extension of the can to secure the overpressure disconnector work.

- folding beads must not be retained by clamps.

2. Maximum allowed fault current of 10 000 A in accordance with UL 810 standard must be assured

by the application.

3. Stress parameters of the capacitor must be within the IEC 60831 specification.

Overcurrent and short circuit protection

 Use HRC fuses or MCCBs for short circuit protection. Short circuit protection and connecting

cables should be selected so that 1.5 times the rated capacitor current can be permanently

handled.

 HRC fuses do not protect a capacitor against overload

- they are only for short circuit protection.

 The HRC fuse rating should be 1.6 to 1.8 times rated capacitor current.

 Do not use HRC fuses to switch capacitors (risk of arcing).

 Use thermal magnetic over current relays for overload protection.

Resonance cases

Resonance cases must be avoided by appropriate application design in any case. Maximum total

RMS capacitor current (incl. fundamental harmonic current) specified in technical data must not be

exceeded.

Re-switching vs. phase-opposition

In case of voltage interruption, a sufficient discharge time has to be ensured to avoid phase-

opposition and resulting high inrush currents.

Vibration resistance

The resistance to vibration of capacitors corresponds to IEC 68, part 2–6.

Max. test conditions:

Test duration

6 h*

Frequency range 1

10 ... 55 Hz*

0.75 mm*

Displacement amplitude

*corresponding to max. 98.1 m/s or 10 g

These figures apply to the capacitor alone. Because the fixing and the terminals may influence the

vibration properties, it is necessary to check stability when a capacitor is built in and exposed to

vibration. Irrespective of this, you are advised not to locate capacitors where vibration amplitude

reaches the maximum in strongly vibrating equipment.

FK PC PM PFC

November 2009

Please read Cautions and warnings and

Page 6 of 8

Important notes at the end of this document.

1...3 4 567 8

下载PDF

与B25667B2607A175相关器件

型号	品牌	描述	获取价格	数据表
B25667B2627A375	EPCOS	Capacitors for Power Electronics	获取价格
B25667B2757A375	EPCOS	Capacitors for Power Electronics	获取价格
B25667B3147A375	EPCOS	Capacitors for Power Electronics	获取价格
B25667B3207A175	EPCOS	Power Factor Correction	获取价格
B25667B3207A175_08	EPCOS	Film capacitors - Power Factor Correction	获取价格
B25667B3247A175	EPCOS	Film capacitors - Power Factor Correction	获取价格