Arizona Microtek, Inc.
AZPB70
Programmer Board for AZT70/71
HARDWARE OVERVIEW
The AZPB70 programmer board comes with all the hardware listed in Table 1. These hardware parts are necessary to
complete the setup shown in Figure 1 which is used to evaluate the AZT70 and AZT71 capacitive tuning ICs. For
production programming and measurement, the AZT70/71 should be soldered onto the oscillator PCB board where the 3
programming pins are accessible through the PCB substrate (Figure 2). Figure 3 and Figure 4 detail the top & bottom
views of the programmer board, respectively.
OSCILLATOR
RESONATOR
OUT
USB Cable
6 pin ribbon cable
X1
Measurement
device
Programmer PCB
Socket adapter board
Figure 1 – AZPB70 Hardware setup for evaluation
OSCILLATOR
RESONATOR
OUT
USB Cable
AZT70/71
DA
X1
CLK
6 pin ribbon
PV
cable
Programming pins accessed
through PCB substrate
Programmer PCB
Measurement
device
Figure 2 – AZPB70 hardware setup for production
www.azmicrotek.com
+1-480-962-5881
2
Request a Sample
May 2012, Rev 1.2