3.
Signal Description
Table 3-1 gives details on the signal name classified by peripheral.
Table 3-1.
Signal Description List
Function
Active
Voltage
Signal Name
Type
Power Supplies
Level Reference Comments
VDDIO
VDDIN
Peripherals I/O Lines Power Supply
Power
Power
1.62V to 3.6V
1.8V to 3.6V(3)
Voltage Regulator, ADC and DAC
Power Supply
VDDOUT
VDDPLL
Voltage Regulator Output
Power
Power
1.8V Output
Oscillator and PLL Power Supply
1.65 V to 1.95V
1.65V to 1.95V
Power the core, the embedded
memories and the peripherals
VDDCORE
GND
Power
Connected externally to
VDDOUT
Ground
Ground
Clocks, Oscillators and PLLs
XIN
Main Oscillator Input
Main Oscillator Output
Input
Reset State:
XOUT
XIN32
XOUT32
Output
- PIO Input
- Internal Pull-up disabled(4)
- Schmitt Trigger enabled(1)
Slow Clock Oscillator Input
Slow Clock Oscillator Output
Input
Output
VDDIO
Reset State:
- PIO Input
PCK0–PCK2
Programmable Clock Output
Output
- Internal Pull-up enabled
- Schmitt Trigger enabled(1)
ICE and JTAG
TCK/SWCLK
TDI
Test Clock/Serial Wire Clock
Test Data In
Input
Input
Reset State:
- SWJ-DP Mode
Test Data Out/Trace Asynchronous
Data Out
TDO/TRACESWO
Output
- Internal pull-up disabled(1)
- Schmitt Trigger enabled(1)
VDDIO
Test Mode Select /Serial Wire
Input/Output
TMS/SWDIO
JTAGSEL
Input / I/O
Input
JTAG Selection
High
High
Low
Permanent Internal pull-down
Flash Memory
Reset State:
- Erase Input
Flash and NVM Configuration Bits
Erase Command
ERASE
Input
VDDIO
- Internal pull-down enabled
- Schmitt Trigger enabled(1)
Reset/Test
NRST
TST
Microcontroller Reset
Test Mode Select
I/O
VDDIO
VDDIO
Permanent Internal pull-up
Input
Permanent Internal pull-down
SAM3N Series [DATASHEET]
Atmel-11011C-ATARM-SAM3N-Series-Datasheet_16-Apr-15
7