TM
OLED SMARTSWITCH Rocker
DEVELOPMENT TOOLS
NKK Switches offers a variety of development tools. These tools include software that may be downloaded
from www.nkksmartswitch.com.
In addition to standard configurations, NKK can provide custom solutions for the most complex design
challenges. Contact factory for information and support regarding your custom applications.
Development Kits provide a full set of tools for designs. The Dev Kits enable rapid prototype designs so
that feedback is easily obtained. NKK’s Development Kits have been designed to facilitate the creation,
testing and displaying of images with software downloaded from www.nkksmartswitch.com. Click on
“Download Software.”
PRECAUTIONS FOR HANDLING & STORAGE
ATTENTION
ELECTROSTATIC
Handling
SENSITIVE DEVICES
1. OLED devices are electrostatic sensitive.
2. Signal input under conditions not recommended may cause damage to the OLED unit or deterioration of the display.
Follow directions regarding supply sequences of power and signal voltages.
3. If the OLED panel is broken, avoid touching the contents. Wash off in case of contact to the skin or clothing.
4. Limit operating force to 100.0N maximum, as excessive pressure may damage the display.
5. Under certain actuation conditions, one side of the rocker and the center switch can both send actuation signals.
6. Pixels acquire diminished brightness over time and use, and those most frequently habituated have greater reduction of
brightness than those less used. To minimize this difference, operate OLED unit so that all pixels are used as consistently
as possible.
7. Clean actuator surface with dry cloth. If further cleaning is needed, wipe with dampened cloth using neutral cleanser and
dry with clean cloth. Do not use organic solvent.
Storage
1. Store in original container and away from direct sunlight.
2. Keep away from static electricity.
3. Avoid extreme temperatures, high humidity, gaseous substances, and all forms of chemical contamination.
Incorrect
Correct
Panel Mounting
•
Before snapping a switch into the panel, align the
gasket evenly under the bezel of the switch.
•
When mounting into a panel, apply equal pressure
to sides of bezel and insert parallel to the panel.
Gasket position must be even with no gaps beneath bezel Gasket secure and flush against bezel
•
•
•
After mounting, be sure there are no gaps between switch and panel. Lightly push into panel.
After installing into panel, do not apply excessive force.
After panel installation and wiring is completed, do not apply force horizontally or
vertically from behind panel.
•
•
Behind the panel, cut area should be squared. If front of panel is painted, do not allow any paint
to collect in corners of cutout to prevent level mounting.
Avoid reinstalling a switch once it has been mounted into panel. This may cause deterioration of
panel sealability.
Clean Edges
www.nkksmartswitch.com • Toll Free: 1.877.2BUYNKK • Tel: 480.991.0942 • Fax: 480.998.1435 • Email: smartswitch@nkkswitches.com
8
5秒后页面跳转
深入解析CS8416引脚说明、参数、技术特点
TPA3116D2功放芯片参数详解、引脚说明
移位寄存器74HC165引脚说明、驱动程序示例解读
深入解析AD9833：DDS频率合成器的卓越性能与广泛应用
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
