Datasheet > AN217

AN217

更新时间： 2022-04-23 23:00:11

品牌	Logo	应用领域
芯科 - SILICON		/
页数	文件大小	规格书
18页	325K
描述
C8051F35X DELTA-SIGMA ADC USER’S GUIDE

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

AN217 数据手册

AN217

Resistor: The resistor value should be high enough for isolation (i.e., at least 10s of ohms) but not too high to

cause settling time problems or gain errors. The gain error can be removed using the ADC’s calibration feature

(see the datasheet for details). When making a differential measurement, the input resistors to AIN+ and AIN–

must be matched to preserve common-mode rejection. It is typically more difficult to match higher valued

resistors.

Capacitor: The capacitor acts as a charge reservoir (supplying the switched ADC sample capacitor) and as a

noise filter. Further, the ADC capacitor switching can be viewed as an average, steady input current. In reality,

the switching creates spikes of charging current that are highly non-linear as the modulator switches the ADC’s

sample capacitor. An external capacitor aids in linearizing the measurement. Electrolytic capacitors should not

be used because they will introduce distortion. Ceramic capacitors work well and should be sized large enough

such that a high valued resistor is not necessary. Typically, capacitors valued in the 1/10th’s of µF’s are used.

A corner frequency below the sample rate (19.2 kHz) is typically sufficient (e.g., R = 100 Ω and C = 0.1 µF) for

most applications.

2.2. The ADC: Configuring the Delta-Sigma

1. Select

5. Configure

7. Calibrate

Voltage

Reference

Input

Buffers

AIN+

AIN-

SINC³

Filter

PGA

Modulator

Fast Filter

8-Bit

Offset

DAC

6. Configure

4. Configure

3. Zero/Tare

2. Gain

Figure 2. Configuring The Delta-Sigma ADC

To achieve a high-resolution measurement, the delta-sigma ADC consists of two basic subsystems: the modulator

and the digital filter. One important concept to understand when configuring a delta-sigma data converter is that the

sample rate is much higher than the output rate of the ADC, so each sample does not result in an ADC output. The

signal is oversampled and then filtered to achieve the high-resolution measurement with reduced analog front-end

circuit requirements.

Rev. 0.2

1 234 5 6 7...18

下载PDF

与AN217相关器件

型号	品牌	描述	获取价格	数据表
AN217P	ETC	用于立体声收音机和收录机的AM调谐器及FM/AM高放、福频、本振、中放电路.	获取价格
AN219	MICROCHIP	Comparing Digital Potentiometers to Mechanical Potentiometers	获取价格
AN-2195	TI	AN-2195 Driving High Speed ADCs with the LMH6521 DVGA for High IF AC-Coupled Applications	获取价格
AN-22	ETC	Designing Multiple Output Power Supplies with TOPSwitch	获取价格
AN220	SILICON	USB DRIVER CUSTOMIZATION	获取价格
AN2200	SEOUL	Acriche series	获取价格