Series AMLDP-Z
Up to 1000mA | LED Driver
General Specifications (continued)
Parameters
Conditions
Typical
Maximum
Units
Weight
Dimensions (L x W x H)
MTBF
1.8
0.50 x 0.40 x 0.27 inches
> 3,300,000 hrs (MIL-HDBK-217 F at +25 oC)
1.5mm from case for 10sec 260
g
12.70 x 10.16 x 6.85 mm
Maximum soldering temperature
oC
NOTES:
1.Reversed polarity at the input power will damage the driver. The input ground must not be connected to the negative output.
2.Leave the pin VADJ opened if not used , grounding VADJ will shut the driver off, connecting VADJ to +Vin will damage the driver.
3.Maximum output open voltage is equal to input voltage
Safety Specifications
Parameters
Agency Approvals
CE
EN55015: 2007+A2: 2009
EN61547: 2009
IEC 61000-4-2: 2008
IEC 61000-4-3: 2006+A1: 2007+A2: 2010
IEC 61000-4-4: 2004+A1: 2010
IEC 61000-4-5: 2005
Standards
IEC 61000-4-6: 2008
IEC 61000-4-8: 2009
IEC 61000-4-11: 2004
NOTE: also designed to meet EN609501
Pin Out Specifications
Single
+ V Input
+ V Output
- V Output
Vadj
Pin
1
4
5
7
8
+ DC Supply
LED Anode connection
LED Cathode connection
PWM/ON/OFF or not used
- DC Supply
- V Input
Dimensions
0.50
(0.02)
7.62
(0.30)
12.70
(0.50)
4
5
1
8
7.62
(0.30)
10.16
(0.40)
Bottom View
7
2.54
(0.10)
6.85
(0.27)
NOTES: All dimensions are in millimeters (inch)
Pin Diameter: 0.5 ± 0.05 (0.02 ± 0.002)
Pin Pitch Tolerance: ± 0.35 (± 0.014)
Case Tolerance: ± 0.5 (± 0.02)
3.05
(0.12)
0.50
(0.02)
2.54
(0.10)
www.aimtec.com
F 051e R12.D
Tel: +1 514 620 2722
2 of 18
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only