AL5809EV1-XXX User Guide
15-150mA 60V Constant Current Regulator
II) Current LED String Procedure in High side current LED configuration
“DC+” Wire
Vcc (Power Supply)
IN Wire
1
U1
IN
AL5809
OUT
2
OUT Wire
External LED String
“DC-“ Wire
1. The evaluation can also be configured as High side current LED configuration.
2. Ensure that the DC source is switched OFF or disconnected.
3. Connect the power supply to DC+ and DC- terminals on the board.
4. Connect the DC+ wire of the board to IN terminal wire on the board.
5. Connect the Anode and Cathode terminals of external LED string between OUT terminal
and DC- wire of the board in the High side LED configuration.
6. Connect the DC- wire to the GND of the DC power supply.
7. Observe MAX 60V differential between IN and OUT terminals when applied Vcc > 60V.
8. In the high side circuit configuration, extreme high voltage may be present. Please use
caution and try not to touch any components on the board or input leads.
9. Turn on the main switch. LED string should light up and the LED current should be
regulated according to the current options of the device.
AL5809EV1-XXX Rev1
February 2015
Page 4 of 12
www.diodes.com