AH1892
PROGRAMMABLE MICROPOWER OMNIPOLAR
HALL-EFFECT SENSOR SWITCH
Absolute Maximum Ratings (TA = +25°C, Note 5)
Symbol
Characteristics
Values
Unit
VDD
Supply Voltage (Note 6)
Reverse Supply Voltage
6
V
VDD REV
IOUTPUT
B
-0.3
2.5
V
Output current (source and sink)
Magnetic Flux Density
mA
Unlimited
Ts
Storage Temperature Range
-65 to +150
°C
mW
mW
°C
U-WLB0707-4
SOT553
160
230
150
8
PD
TJ
Package Power Dissipation
Maximum Junction Temperature
Human Body Model ESD
VDD, GND and OUT pins
BSEL pin
kV
ESD
6
kV
Notes:
5. Stresses greater than the 'Absolute Maximum Ratings' specified above, may cause permanent damage to the device. These are stress ratings
only; functional operation of the device at these or any other conditions exceeding those indicated in this specification is not implied. Device
reliability may be affected by exposure to absolute maximum rating conditions for extended periods of time
6. The absolute maximum VDD of 6V is a transient stress rating and is not meant as a functional operating condition. It is not recommended to
operate the device at the absolute maximum rated conditions for any period of time.
Recommended Operating Conditions
Symbol
VDD
Characteristics
Supply Voltage
Conditions
Operating
Operating
Rating
1.6 to 3.6
-40 to +85
Unit
V
TA
Operating Temperature Range
°C
Electrical Characteristics (TA = +25°C, VDD = 1.8V, unless otherwise specified.)
Symbol
VOL
Characteristics
Output low voltage (on)
Conditions
IOUT = 1mA
IOUT = -1mA
Min
Typ
0.1
Max
Unit
V
0.2
VOH
VDD -0.2
VDD -0.1
Output high voltage (off)
Band select low band
V
BLsel
0
0.5
3.6
V
BHsel
Band select high band
1.4
V
RU_BSEL
IDD(awake)
IDD(sleep)
IDD(avg)
IDD(avg)
Tawake
Tperiod
D.C.
BSEL pin internal pull-up resistor
(Note 7)
During ‘awake’ period
During ‘sleep’ period
VDD = 1.8V
50
2.1
2.5
4.3
7.2
50
kΩ
mA
µA
µA
µA
µs
ms
%
Supply current
8.0
13.0
100
100
Average cupply current
VDD = 3.6V
Awake active pulse width
Awake period
(Note 8)
(Note 8)
50
Duty cycle
0.1
100.0
TBand
Band transition time
( Note 9)
200.1
ms
Notes:
7. BSEL pin internal pull-up resistor is only active during AWAKE time.
8. When power is initially on, the operating VDD (1.6V to 3.6V) must be applied to guarantee the output sampling.
The output state is valid after the second operating phase (typical 100ms).
9. Transition time varies dependant on the timing of BSEL activation during the sleep and awake phases.
3 of 11
www.diodes.com
May 2012
© Diodes Incorporated
AH1892
Document number: DS35092 Rev. 1 - 2